Your cart is empty.
Your cart is empty.
Phoenix goods Urethane Bandsaw Tires, .095" Thick, 2 Pack
How to install
First, After disassembling old "tires", clean up the gummy debris left on the wheels.
Mounting:
Used a clamp to hold the tire on the wheel in one spot, and then used a screwdriver to pry the rest of the tire on. This made installation relatively easy
Uniform stretch:
After mounting, removed the clamp and pushed the shaft of the screwdriver completely under the tire, so it was between the tire and rim. Then ran the screwdriver around the wheel several times to make sure the tire was uniformly stretched around the wheel.
Seating the tire:
Next, made sure the tires were properly seated in the groove on the wheels, rolled the wheel on a concrete floor, pushing down pretty hard with your hands, so the concrete would forced the tire into the groove.
After mounting, reinstalled the wheels and readjusted everything, finish!
✅Urethane band saw tires no adhesive needed, but need to be stretched on. If your new band saw tire is too tight to fit onto the wheel, submerged the new tire under hot water for a few minutes, this will make things easier.
Steven McKeown
Reviewed in the United States on September 19, 2023
The belt seems to be quality made enough, but it didn't last as long as I thought it should. Could have been my machine, but I rarely used my band saw and it only lasted for a few dozen uses over a year's time. Maybe that's all they are supposed to last, but the one I had on before lasted for probably 7 years at the rate I use my saw.
D. Mackinson
Reviewed in the United States on August 28, 2023
New tires arrived quickly and went on the saw easily. Using two strong spring clamps and slowly stretching the tire around the wheel took 30 seconds each. Simple replacement and the new blade tracks perfectly!
Customer
Reviewed in Canada on June 8, 2022
Pour remplacer sur ma scie à ruban Delta
Garrison
Reviewed in the United States on June 6, 2022
Everyone seems to have a hard time installing these. It took me three tries but I got this tire on fairly easily with only a bit of tenacity and patience. I did not remove the wheel. I did use a small clamp to hold the tire to the wheel in one place, while I worked the tire on the wheel the rest of the way with my bare hands. Works great after tensioning the blade and setting the tracking correctly. Anyway, I'm happy and the Delta is as good as new again.
Guy Massicotte
Reviewed in Canada on May 15, 2022
Les pneus remplacent parfaitement ceux d’origine
City Oasis
Reviewed in Canada on October 30, 2022
Fit like a glove
OldGuy57
Reviewed in the United States on August 28, 2021
They fit perfectly and exactly, and are obsolete from Delta. I was shopping for a new saw and ran across these when I searched for my model number. They saved me hundreds, probably over a thousand dollars, as I was looking at new saws in a similar and slightly larger size.These are well worth the money, and I will order a spare set now that I have seen the quality.
Edward D. Lance
Reviewed in the United States on August 10, 2021
A little difficult to put on, but once on, they are great. I used 2 pairs of vice grips with a thin piece of wood under the jaws so as not to cut or mar the tire. Clamp one on, then put as much of the tire on as you can, and then clamp the 2nd one as far down as you can. Once clamped in 2 places, you can pull and stretch it the rest of the way by hand.You'll have to remove the wheels from the saw to get them on.
KC
Reviewed in the United States on March 3, 2021
This is a perfect fit for my Delta bandsaw. They are almost impossible to install without a heat gun. But you want them tight after the install. I found it easiest to remove the wheels first.
Robert H.
Reviewed in Canada on February 21, 2021
They were a tight fit, so it took me an hour to figure out how to get the first one on. The second one was on in twenty minutes. So far am completely satisfied with them
BK
Reviewed in the United States on December 30, 2021
I thought these bands would work great for my little bandsaw. They were a little difficult to get on but after some hot water they became quite pliable. I actually didn't get around to installing them for 6 months after I bought them but upon first use the band snapped where it was clearly welded together. Pretty disappointing overall.
Peter w.
Reviewed in Canada on October 24, 2021
Arrived much sooner than delivery date quoted. Easy to install and perfect fit. Saw now tracks more accurately and much quieter
ES
Reviewed in the United States on October 7, 2020
Replaced the original tires because my saw had a bad vibration. Installed these by myself in about 10 minutes with a couple of clamps, and a flat screwdriver for leverage. They seem to be good quality and my saw is vibration free now.
Recommended Products
