Shopping Cart

Your cart is empty.

Your cart is empty.

5mm Solid-Carbide Up-Cut Spiral Router Bit, 5mm D, 5/8' CL, 1/4' Shank

Free shipping on orders over $29.99

$23.66

$ 12 .99 $12.99

In Stock

About this item

  • 5mm Diameter
  • 5/8" Cut Length
  • 1/4" Shank


Youll achieve smooth accurate cuts without chatter in any wood, hard or soft, with these Solid-Carbide Router Bits. The spiral design pulls waste material from the cut and leaves a flat-bottomed mortise, and teach bit is machined from solid carbide to production quality standards.Solid carbide cuts smoother and runs cooler to stay sharp longer. Up-cut bits offer better chip ejection. Perfect for mortises, stopped dadoes and plunge cuts. Metric sizes to work with Festool Domino loose tenon joinery1/4" shank.


Scott
Reviewed in the United States on March 14, 2025
Very clean cuts, sturdy tool. Using it to build new doors and drawer fronts for my kitchen cabinets.
rms
Reviewed in the United States on July 18, 2024
The bit was made with the usual high quality that I associate with Whiteside, which is why I buy from them. The upward spiral causes the bit to pull upwards ruining the work and putting my hands at risk. This has happened to me four times now with this type of bit. This is despite retightening, taking the router out of the table and retightening with an extra long wrench, making sure there were no wood particles in the collet and even replacing the collet. The cut was a 1/4 inch deep stopped dado on ash. I will only use dado bits with straight parallel blades from now on.
Used_to_be_a_Sony_Fan
Reviewed in the United States on November 23, 2023
Fulfills a need for cutting holes for 5 mm shelf pins. Provides clean cuts in both hardwoods and veneers.
Donald J. Clark Jr.
Reviewed in the United States on January 15, 2023
Used on thin stock cherry and really liked the clean cut and precision of this bit. Feels like it could cut forever. The heft of this bit makes me believe it will never break.
RICK
Reviewed in the United States on June 15, 2022
Used this in a small plunge router for shelf pins. Cut's clean holes. Had zero bad holes.
jon wayman
Reviewed in the United States on November 11, 2022
very well packed , came on time, very pleased with the product.
Martin Batten
Reviewed in the United States on January 31, 2021
Bought and used this to make blind holes in a cabinet for shelf pins.The pins were 5mm. But they ended up being loose in the holes.Nice clean cut though.
whiskeynwood
Reviewed in the United States on June 25, 2018
Works pretty well, but disappointed that it isn’t as clean of a cut as I hoped for, far better than a drill for 5mm shelf pins, but still takes too much clean up time for the number of holes I have to do regularly, I’ll keep looking. Works great for linear cuts, just not ideal for plunge.
Recommended Products