Your cart is empty.
Your cart is empty. Product Description
BOJACK 2ps 40 Amp AGU Fuse Holder with 8 Gauge AWG 1ft Power Wire - 99.9% Oxygen-Free Copper
Product information:
Fuse holder type: AGU fuse holder
Premium Copper Wire: 1ft of 99.9% Oxygen-free Copper Wire
Advantage:
This AWG power wire is constructed with 99.9% oxygen free copper wrapped, Crimp Ring Terminal with soft touch rubber jacket, which provides good protection and excellent safety performance.
Package include:
【Product contains】：2 pcs AGU Fuse Holder, 2 pcs 40A Fuse, 2 pcs 1ft of 99.9% Oxygen-free Copper 8 Gauge Wire
cameron petersen
Reviewed in the United States on August 9, 2024
Exactly what you expect and the fuses are good quality
Madjay
Reviewed in the United States on July 8, 2024
Good quality for sub amp install
Jonix
Reviewed in the United States on July 16, 2024
works well.good thick wire
Al Carter
Reviewed in the United States on May 28, 2024
Solid wiring and good grip of the fuses within the fuse holder. The connections are tight which is good for overall performance. The ring terminals are heavier duty that most and are pre crimped well.
OregonBob
Reviewed in the United States on October 15, 2024
I had to run a heavier battery cable to a junction box on boat. I needed a fuse on the positive cable. All went well except the cord already connected was tightened and disconnected. I didn’t realize it wasn’t tightened. Reconnected tightened set screw and good.
Albuquerque hiker
Reviewed in the United States on January 22, 2024
These are as easy to install as any inline fuses or breakers. While a lot of people may use these for car audio, I wanted them to protect the wires with 50A and 60A connectors in my portable solar setup. Their thick 8 AWG wire should not have problems handling a load of up to 60 AMPs and if I do get a load above 60A but below the 100A where the LiFePO4 battery's BMS (battery management system) will shut off the current then this fuse should blow long before the 50 or 60A limit of the connectors (or the 8AWG wire) can become a problem. So far so good.
Daniel J. Zieler
Reviewed in the United States on April 19, 2024
It's important to protect all your electronic systems with fuses or breakers and this inline fuse system makes it very easy to do. It is a nice visual system to for knowing the status of the fuse, good or blown. It also is made to support your beefier wire gauge of 8 awg. This fuse system is good for vehicles and solar systems and is made of quality materials. It allows for various amp fuses using the same fuse holder and all for a reasonable price.
No one of any importance
Reviewed in the United States on December 27, 2023
Easy to install these fuse units to connect up to a relay fuse box.Made from 8 AWG wire, this will not problem handling the load of 60 AMPs I am throwing at it under full load.Not mush to say about a fuse and holder, but it looks good and will more than do the job it is meant for.Good value for the money, will it last? only time will tell.
Recommended Products
