Shopping Cart

Your cart is empty.

Your cart is empty.

ACC Automotive Carpet Compatible with 1985 to 1991 Chevrolet Blazer, 4 WD Complete Kit (8019-Mist Grey Plush Cut Pile)

4.6 (2) Write Review
Free shipping on orders over $29.99

$386.95

$ 99 .00 $99.00

In Stock

1.Color:2000-yellow Neon Cut Pile


About this item

  • This item is made in 8019-Mist Grey Plush Cut Pile carpet. The item image may be a different color, but the SWATCH image is the correct color. Carpet Fits 4 WD Complete Kit. Unless otherwise noted, the jute padding is heat bonded to the backside of the carpet and a heel pad is welded to the correct location.
  • Holes may not be cut in automotive carpet and carpet may require trimming to install. PLEASE FIND THE INSTALL INSTRUCTIONS ON THE HELP TAB IN OUR STORE DETAILS PAGE.
  • Automotive carpet compatible with Chevrolet Blazer will be Heat and Pressure formed using a form that was created from the original floor pan. Carpet is guaranteed to fit to the floor when installed correctly.
  • All automotive carpets are Made in USA with Top Quality auto carpet materials. IF YOU ARE NOT 100% SURE OF THE COLOR/MATERIAL YOU NEED, PLEASE CONTACT US BEFORE ORDERING.
  • Automotive carpet will fit just like original carpet when installed correctly and is Guaranteed against Defects. This item fits the years: 1985 1986 1987 1988 1989 1990 1991


  • This automotive carpet will be made in 8019-Mist Grey Plush Cut Pile. Other colors and materials may be available in the selection above.
  • This carpet is a replacement for 1985 to 1991 Chevy Blazer, 4 WD Complete Kit. This kit includes the passenger area carpet, rear cargo area, wheel wells and pillar panel. Padding not included for Cargo Area.
  • Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
  • Unless specified, the jute padding will be attached in the foot area of the carpet
  • Installation may require trimming around the edges and the holes may need to be cut.
  • There is a large variety of colors available. Please request free samples if you want to match a specific color
  • This item fits the years: 1985, 1986, 1987, 1988, 1989, 1990, 1991, 85, 86, 87, 88, 89, 90, 91

READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets

1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. Use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once carpet is properly fitted, do the final trim on outer edges, seat belts, holes, etc

Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.


Oswaldo
Reviewed in the United States on May 9, 2024
Carpet is really thin, looks great but it’s really thin and feel like it’s made pretty cheap , I was expecting better quality , but it does fit I gotta give that to them you have to do some trim work though
daniel kelting
Reviewed in the United States on September 8, 2021
The carpet looks fine but there’s a little to know felt backing on the carpet at all