Shopping Cart

Your cart is empty.

Your cart is empty.

VMTW 8X1 inch CBN Grinding Wheel Set 80 Grit & 180 Grit High Speed Steel Tools

4.6 (2) Write Review
Free shipping on orders over $29.99

$186.66

$ 77 .99 $77.99

In Stock

About this item

  • Pair of Precision Made Solid Aluminum body 8" diameter by 1" with CBN on the face and 1/4" sides of the wheel. For 5/8 inch shaft.
  • Designed for use with slow speed 8 inch bench type grinders; 1800 RPM or 3600RPM Now comes with 4 precision ground washers to help in positioning the wheels on your arbor shaft.
  • Will never need dressing, or truing. Wheel Diameter stays the same, so you will not need to be keep adjusting your jig.
  • Use with High Speed Steel (HSS)Tools Only
  • Note: These wheels are made with very tight tolerences. The arbor hole is precisely cut to .6254 inches. The shaft on many grinding motors are not as percise, and may be slightly larger then .625 inch. This will cause an interfearance fit. A little bit of emery cloth on the shaft will help get the wheel on.


Size:8", 80 Grit and 180 grit, 1.0" Wide, For 5/8" Shaft


dadbecker
Reviewed in the United States on August 15, 2022
My old grinding wheels needed replacing so I spent the (much more) money. Significantly better grinding surface that should outlast the grinder makes this worth the cost.
Foxie
Reviewed in the United States on December 6, 2021
I bought this CBN wheel to sharpen my woodturning tools. My Rikon slow-speed grinder is built for 1" wide wheels with hubs 1" wide. These wheels have a narrower hub that requires additional washers over that of the 2 washers supplied. The nut on the shaft wouldn't tighten up against the hub washer because the nut ran out of thread before it could.