Your cart is empty.
Your cart is empty.
High-quality, "build-your-own" cable kit suitable for generally any motorcycle clutch application
One end of the inner wire is fitted with a barrel nipple (nominally 6mm dia x 10mm). The opposite end will need to be cut to length and the required nipple soldered into place.
PLEASE NOTE: We strongly discourage the use of a propane type torch to heat and flow solder into the wire. This is likely to overheat the wire, causing it to become brittle and break. We recommend immersing the wire ends in a molten solder bath, such as that in a solder pot.
The ferrules and adjusters are a snug fit. They may be bonded into place if preferred, or you can use a center punch to make a small indention in the side.The Kit Includes:
2.35 meters (7.7 feet/7 feet 8.4 inches/92.5 inches) of 7mm OD black PVC coated, spiral wound, Teflon lined outer conduit
2.6 meters (8.5 feet/8 feet 6 inches/102 inches) of 2mm OD galvanized steel wire (1 x 19 strand)
1 ferrule, 6.5mm OD nose
1 ferrule, 7mm OD nose
1 ferrule, 8mm OD nose
1 neoprene adjuster boot
1 brass barrel nipple, 8mm DIA x 9mm
1 brass barrel nipple, 6mm DIA x 10mm (2.1mm bore)
1 brass trumpet nipple, 6mm -> 3.5mm OD, 2.5 ID, 9.5mm length
1 N8 nylon nipple sleeve, 8mm OD
1 N10 nylon nipple sleeve, 3/8" OD
glenda bayard
Reviewed in the United States on September 27, 2024
lighter wt than i thought, but will work
CB
Reviewed in Canada on May 6, 2023
Product was supposed to be 92” long I believe and it was only 36” long. False advertising. Sent it back
Anthony Barnes
Reviewed in the United States on April 19, 2023
These took so much attention to actually fit bulbs to big for throttle leads had to almost fab the entire product
excavator
Reviewed in the United States on December 20, 2022
Nice heavy duty cable,would be even better if it came with a solder free end,but we'll worth worth the money
Fixin 2b fixin
Reviewed in the United States on September 13, 2021
2 months in still good not stretching on a 07 vulcan made a solder bath opened the end of cable a little after fitting was on cleaned flux solder pretty standard and it held the solder well
Leszek
Reviewed in the United States on November 26, 2021
I used it for Victory King Pin clutch, is working very good, just had to shaved the cable head and cut the cable after instalation, was little too long but saved over $100 for the oe victory clutch cable
Jacob B.
Reviewed in the United States on November 16, 2020
Very nice kit well made quality cable and outer housing the kit comes with all the fittings you could generally need
Recommended Products
$19.90
$ 9 .99 $9.99