Your cart is empty.
Your cart is empty.Product Description
Product Description
Describe:
Table Inserts (pack of 2).
Material: Aluminum
Make sure your insert recess has the locating pin on the side, not on the rear.
use on 14" Band Saws and 24" Scroll Saws.2&1/2" X .100 thick Please measure your saws recess to ensure proper fit. They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
Two inserts to protect your expensive blades
Attention:
Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please don't buy it.
IMPORTANT INSTALLATION NOTE:
I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
John
Reviewed in the United States on March 8, 2025
It fits my hHrbour Freight 14 " band saw with a little filing.
Customer
Reviewed in the United States on February 18, 2025
These say 2.5" but they are enough out of tolerance that I had to pound them into the recessed hole in the deck. It shaved some material off and I cleaned up the fit.If all knockoffs are this much off, I'd find plastic ones that can be shaved easier if necessary.
Ralph Hausler
Reviewed in the United States on January 15, 2025
I had to adhere a plastic insert to the bottom to bring it up to table height. Fit is good but thickness is not.
Amanda L. Jordan
Reviewed in the United States on May 16, 2024
Like others said, you’ll have to take some of the coating off and i just used my wire wheel on the bench grinder. Used a soft hammer and there you go. Definitely better material than plastic ones too. I use my band saw for my smoker wood
Ron Reneau
Reviewed in the United States on December 22, 2024
Good quality but a little too large diameter for my saw
kevin earl
Reviewed in the United States on October 9, 2024
Works
Notbhavn
Reviewed in the United States on October 12, 2024
Had to "persuade" it in to my Ridgid bandsaw as it was a tad too tight...but it works.
Chris Cohick
Reviewed in the United States on December 29, 2020
I bought these to replace the worn out plastic originals for my Ridgid bandsaw. The fit was a bit snug, but I suspect that is by design. Exactly what I was looking for. I would buy again.
Recommended Products
$43.20
$ 21 .99 $21.99
$44.20
$ 20 .99 $20.99