Your cart is empty.
Your cart is empty.
Skunk2 is synonymous with innovation, so it’s no surprise that its engineers took the company’s highly successful and widely copied Pro Series Ball Joints and made them even better.
V2.0 Pro Series Ball Joints are compatible with '92-'00 Civic and '94-'01 Integra Tuner Series, Pro Series, and Pro Series Plus Front Camber Kits and though they may look similar to their predecessor on the surface, they aren’t! V2.0 Pro Series Ball Joints help alleviate typical clearance problems normally associated with lowered cars and aftermarket, adjustable ball joints. Typically, the front, upper A-arm’s ball joint’s range of motion maxes out on lowered cars, causing the suspension arm to bind at the joint. Skunk2’s NEW Ball Joints reduce this problem further thanks to a 3mm larger diameter pivot ball and a notched housing that allows for increased range of motion and increased strength. A high quality Teflon liner is also used to surround the ball joint for smoother operation, while the rubber boot that houses the ball joint now utilizes a crimped design that allows for the increased angle, adding both durability and longevity.
NOTE: There is no solution for premature wear or failure on excessively low vehicles. Skunk2 camber kits are designed to correct negative camber introduced when lowering a vehicle (within reason) and/ or to introduce a desired amount of camber for maximum grip on race cars. Skunk2 Camber Kits and Replacement Ball Joints were not designed to introduce or be used in extreme negative camber environments which can/ will cause premature wear and eventual failure.
vteciiguess
Reviewed in Canada on May 19, 2024
Bought these to replace the old ones, will only work with Skunk2 adjustable upper control arms. Tip: remove the rings and add more grease to the boots for longevity, then put the rings back on. Most people don’t do this, they will only last a year or two otherwise.
rob s.
Reviewed in Canada on June 4, 2023
Fast shipping real deal part
Customer
Reviewed in the United States on May 16, 2023
Fast shipping great product and service 💯✅
ivan flores
Reviewed in the United States on January 30, 2023
Fits perfect
Jean-Séb.
Reviewed in Canada on May 15, 2022
Excellent
Brian
Reviewed in the United States on May 16, 2020
Bought these to replace the ball joints do my skunk tuner control arms. Fitment was great. I do recommend pulling the boot off and adding grease to the ball joint as the amount of grease they put on installation is towards the minimum of acceptable.
Phantom-Devil
Reviewed in Canada on April 13, 2020
My last ones lasted me 6 years and about 200,000km+
Fallen skater
Reviewed in Canada on June 20, 2019
Fits aftermarket camber arms great quality
Tony
Reviewed in the United States on December 29, 2019
They fit as intended, and the shipping was great as well.
Tink
Reviewed in the United States on December 24, 2018
I didn’t read the description I just ordered thinking it came with 2 but no biggie I can order another
balto113
Reviewed in the United States on October 14, 2015
works great. Direct fit on the cheap eBay camber kit arms.
Eric
Reviewed in the United States on February 16, 2014
Skunk 2 replacement joints work good but only last approximately two years before they need to be replaced again. Good quality
Hay
Reviewed in the United States on October 22, 2014
Exactly what I needed, it was the same thing as my old ball joint just an updated version. (Different boot and hold down bolts) fit without issues and works perfect.
Recommended Products
