Your cart is empty.
Your cart is empty.
1, Screw Mount 30A/300V 20 Position Screw Terminal Block Distribution Module.
2, Terminal Block: Pitch 7.62mm/0.3", Strip length 8mm. Screws - M3,steel,Cr3+ Zn plated. Pin header and Cage - Brass.
3, Wire range 26AWG ~ 10AWG / 4.0mm square. Rated voltage 300V, rated current 30Amp(per position).
4, Taiwan High quality fireproof nylon material mount carrier(not China low quality carrier). Also included are two M3 x 10mm wood screws, you can easily mount it on a wooden board.
5, External dimensions: L175mm x W48mm x H37.3mm / 6.89" x 1.89" x 1.47"
Jlamb
Reviewed in the United States on February 7, 2021
Good product, does what I wanted it to do.
Kelly S.
Reviewed in the United States on February 27, 2021
I like to use a terminal block to separate the boat's circuit breaker panel from the wiring going to the various loads. These blocks are a much nicer option than the standard "bus bar." Each of the 20 positions is well numbered (both below and above) where the wire inserts so you're probably not going to mis-connect a conductor. The screws for tightening down on the conductor are as expected a standard screw driver. A 10 gauge wire easily fits in the terminal blocks points.The other thing that I really like about this block for an ac distribution is that it's going to be pretty hard to shock yourself because all of the metallic points are either recessed or mostly inaccessible. I bring this up because several previous boats which I have worked on had the typical open faced terminal blocks which you could (in a tight space) brush up against and shock yourself.Overall, this is a nicely executed product and I am glad to have used it on my sailboat.
Jaye Merrell
Reviewed in the United States on February 20, 2021
This worked out perfect for my garage audio system I made.
Recommended Products
