Your cart is empty.
Your cart is empty.RELTON A9-NRT-KIT Rapid Tap & A-9 Cutting Fluid Combo Pack (Pint and 4 oz.)
Customer
Reviewed in the United States on May 8, 2023
As an amateur machinist, I use a lot of this cutting fluid when running my lathe. Also the best for taps & dies. It`s clear liquid and cleans up easily. It works great, but I think the formula has changed to make it friendly to the environment. The Rapid Tap that I got years ago, would cut right through Kryptonite....
Virgil N.
Reviewed in the United States on November 5, 2020
Great stuff
Edward O. Wolcott
Reviewed in the United States on May 25, 2016
Works beautifully for deep hole drilling and tapping in Aluminum. Only a little is needed.
Jason Akers
Reviewed in the United States on May 11, 2015
I've Always trust Relton products, verry pleased.
Steve
Reviewed in the United States on March 7, 2015
A-9 for Aluminum works well for drilling & tapping alu, rapid tap works ok for milling, smokes a bit, haven't used for drill/ tap yet, I am sure it is good for that too.
Robert
Reviewed in the United States on April 3, 2015
Not bad.. not bad at all. It this stuff works. Not much to say, if you need tap fluid or similar for cutting, threading etc... give this set a chance. For my small hobby CNC it's been great so far.
Recommended Products
$19.99
$ 8 .99 $8.99