Your cart is empty.
Your cart is empty.Product Description
R. Nelson
Reviewed in the United States on January 18, 2025
Having used a similar set on my house from another company that doesn't seem to be around anymore, I was glad to find these for my sister's house. Good quality, good water intake rate. I love that the fine stainless grid doesn't take in gravel from the shingles, it washes off.
Dave in Florida
Reviewed in the United States on September 7, 2024
The gutters installed on our Florida home last year are a bit too wide for most gutter guards. These are a bit wider and worked well. I have installed 180' so far with about 50' to go. Our exterior walls are ten feet high. My 8' stepladder was more than sufficient to work with. I'm seventy-eight next week and spent about twelve to fourteen hours so far. Most of that time, however, was spent in cutting 24 pieces at forty-five degrees for the 12 ninety degree angles on our roof/gutters. Make sure you install them going from left to right. Each piece has an overlap of just the mesh part of a half inch on the right side which will overlap the next piece. I bent that overlap down a bit so that, when installing the next piece, I lift up the end of the piece I just installed and slide next piece left and under the previous piece. I then put one of the supplied screws in near the end of the previous piece, thus holding that junction down to the gutter edge. Each piece goes under the shingle on top of the drip edge, so it is held in place there. My entire installation was done with just the one screw at the right edge of each piece. There is a short "leg" on the front edge of each piece which rests against the inside edge of the gutter, so, if both ends of the 45" piece are held down, they're probably not going anywhere unless a large tree limb or something falls on them which would destroy them anyway. If you had two or three screws holding them to the gutter, you'd just have to remove more screws to do any replacement. Speaking of which, if you DO have large trees over the house or even near it, you probably should make sure you have some extra pieces for replacements. You should order the sample to make sure they are wide enough to work on your gutters. Have a stiff putty knife to carefully lift the edge of the shingles to slide the test piece under. If you live up north, don't install these in very cold temperatures unless the sun has warmed the shingles. You don't want to risk breaking of the edges of the shingles where they overhang the metal drip edge. Bottom line - installing these yourself might take a weekend or two, but you will save thousands of dollars.
ckone
Reviewed in the United States on September 14, 2024
Easy to install will keep the smallest debris out. I had to order 2 sets to finish my house; 1level ranch. Price is right and good quality
Ibuprofen
Reviewed in the United States on May 18, 2024
I got a 45 feet pack and a 90 feet one to cover my gutters. The packages include stainless steel self-tapping screws and a nut driver socket. After installing, I had just one 45 inches section left and a lot of screws. I like that they offer stainless steel screws, I don’t want to see any ugly stains on my white gutters after years of use.Before installing, I gave these gutter guards a little test run. I dropped some pine needles on the fine mesh, and not a single one slipped through or got stuck on top. Plus, I ran water over them, and it all flowed right through the mesh like a charm.Installation was easy and quick after getting familiar with the first two pieces. Better to follow the instruction they post on Amazon, the pamphlet comes in box is a bit basic though.Each section is precisely 45 inches long and I noticed all my gutter openings are covered by the fine mesh, I believe this is helpful to get all rain into the gutters. The build quality is exceptional. There's a bit of mesh that extends off the right end of each section, making it super easy to close off the gap between sections. Installing them from left to right was a piece of cake, thanks to this neat overlap design. It ensures a seamless connection between sections, which means less chance of debris building up.For roof corners, I simply used tin snips to cut the gutter guard, following the manufacturer's instructions. It only took a few minutes to master, and the end result was flawless.
Rodney Harrison
Reviewed in the United States on November 10, 2024
This is a great guard if you have some experience with gutters and don't want to pay for contractor services. I have seen more durable guard, however this guard is up in the higher end of quality. It's a thoughtful yet simple design. The guard already comes pre cut for making nice tight fits along with a driver bit and stainless steel screws. These guards work great for various types of installations, while increasing the existing gutter durability and function. Just for information sake this guard does not come with end caps, which is needed with certain types of installations, but not most.
Jerry
Reviewed in the United States on October 22, 2024
This is easy to install. The best protection and best price per foot. As a contractor I've installed many different types and this is the one I recommend for best protection. Quality construction and easy installation and best price in its class. I give 5+ stars.
Chad Spellars
Reviewed in the United States on October 13, 2024
I'm happy with the design and ease of installation, and the seller was very responsive when I reached out with questions. The only concern I have is the strength. These guards will definitely keep out leaves, bugs, and pine needles... but if large or medium size tree debris falls on these gutters, can they stand up to it? Giving five stars for now because it seems like a very high quality product so far, and they fit perfectly. (Before and after photos shown above)
David
Reviewed in the United States on October 11, 2024
The issue you will have with this is it is not very strong , so when you try to side it under the shingles. You will most likley bend this while installing it. Better cover cover have backers screen tha support the microscreen that allows for better instllation. The othe isue with this becuase it has no support backer it will recieve more dammag foom falling tree debris
Recommended Products
$50.41
$ 22 .99 $22.99