Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
Lefty
Reviewed in the United States on May 2, 2024
I found out through searching the PT forums/groups that these will fit 01-10 cruisers. I had lowering springs installed and needed new bump stops because the original ones crumbled apart. I cut off about an inch on the top (thinnest) part of each one. Tricky to install. First, I used some soapy water to make them slip in. Then a used a board and a 2 by 4 and crowbar them in. They popped right in. Super easy if you know the trick. Hopefully, this will be the last pair I'll need for this car.
1986CC38
Reviewed in the United States on April 1, 2022
Easy to install and improved handling by limiting roll.
Matty P
Reviewed in the United States on April 3, 2021
Fit my Chevy truck perfect, just had to shorten them by cutting at the second groove with a hacksaw. There is no urethane replacement listed for these trucks but with a little modification these worked perfect. Like all prothane products, they will last the lifetime of the vehicle especially up north where we undercoat with oil that eats away at conventional rubber products.
🐃 Buffalo Blue
Reviewed in the United States on September 28, 2016
These are an easy replacement & upgrade for the oem stock styrofoam bump stops that came with the PT Cruiser. The sway bar I have installed is an identical red color as these red bump stops, so it looks really nice, very easy to install.
DS
Reviewed in the United States on July 22, 2016
Just as advertised,thanks!
Handy
Reviewed in the United States on January 2, 2015
The original bump stops on PT Cruisers are made of very fragile foam rubber. This is true on all models from 2001 to 2010. After a while, the foam bump stops start to crumble and far apart. These nice red polyurethane bump stops from Prothane are a great fix for this.My only issue is that the pairI received in the Prothane box were not identical. One had a very shiny finish and the other was much duller. I tried applying some Prothane lube and other compounds to the dull one to shine it up. But it was just not the same. I installed them anyway because after a week or two beneath the car, I figured they will not look that different.This is the only reason I did not give these a five star rating. Obviously, a little better quality control on the part of Prothane would likely fix this issue. But since this is just a purely aesthetic issue, I believe four starts is still in order.
B. Coop
Reviewed in the United States on January 3, 2014
I installed this on a 2005 PT Cruiser Convertible. I kept trying to find a bolt that needed to be removed. These just push in and out. A small flat screwdriver helps to pry the old one out and by pressing in the grove of the new one it will slide right in. This looks to be a much better product than the OEM part. I highly recommend this product.
Recommended Products
