Your cart is empty.
Your cart is empty.Product Description
Joe Anubis
Reviewed in the United States on March 12, 2025
Total garbageNot compatible with my vehicle unlike it's listed "compatibility" plug doesn't match existing equipment. All around waste of time and money do NOT order this product
Ted C
Reviewed in the United States on February 22, 2025
Works as described.
Doyle May
Reviewed in the United States on November 10, 2024
My sons windshield has never been cleaner.
netzien
Reviewed in the United States on June 22, 2023
Solid and easy plug and play replacement for the factory originals. Pump and seal fit perfectly into the tank, the wiring connector is a perfect match, click and off you go. Make sure you press the connector in fully until you hear the click, otherwise you may not get a complete circuit.The pumps move fluid at a good rate, no difference from the originals.You will not need to connect the air return hose to the pump that the OEM has, just either ignore it, or remove the hose completely. It only runs up to the wheel well with a u-bend air intake attached at a y-connector. Easy to get rid of. Or just leave it hanging at the tank. (i removed the ones on my vehicle).An easy 10 minute job if you only have to replace the pump(s). I have to replace the entire run of hose as well, that takes a lot longer...
S. OLEARY
Reviewed in the United States on May 15, 2022
Bought a pair of these for my wife’s Nissan Pathfinder. Both pumps went out….but after 19 years, I guess the OEM pumps were past due for replacement. (It’s a 2003)Took a morning to remove the right side inner fender to access the washer bottle. Once in there, the old pumps came out and the new ones went in easily.The only thing different was the OEM pumps had 2 hose nipples where the replacements only have 1. This was easily remedied by simply joining the 2 hoses that did not carry fluid from the washer bottle.Easy install, tested to ensure everything did what it was supposed to and buttoned it all back up. Took about an hour but most of that was removing and installing the inner fender.
Kris Angelov
Reviewed in the United States on March 21, 2022
Purchased this to replace on an Xterra. Once I received it I found out it doesn't include the rear window and also the power plug is different.
txcelt
Reviewed in the United States on November 13, 2021
Fit perfect and works great. Simple installation. Use a lubricant to help fit the rubber grommet back in. Without a lift it's just a tough angle to insert the new one.
Curly Quiz
Reviewed in the United States on July 29, 2020
EZ install. Perfect fit for 2001 Frontier! including electrical plug.The only small removal challenge is unplugging the electric connection.. Use a small screwdriver. All the old washer fluid is gonna drain out when you pull the pump.. The hardest part was getting down on the ground ;-p. Didn't even need a jack. It was very accessible . Here are the installation instructions;Step 1) Plug in electricstep 2) Install O ring gasket first separately.step 3) Then pop in the pump, a little petroleum jelly helps. Not required.Step 4) Attach small discharge hoseI have super washers now!
Recommended Products