Shopping Cart

Your cart is empty.

Your cart is empty.

MECCANIXITY Fully Threaded Rod M5 x 25mm 0.8mm Thread Pitch 304 Stainless Steel Right Hand Threaded Rods Bar Studs 15 Pack

Free shipping on orders over $29.99

$6.79

$ 2 .99 $2.99

In Stock

1.Size:M8 X 35mm


About this item

  • The fully threaded rod is mainly Used for assembly fastening, screwing into threaded nuts or tapped holes., U-bolts or hangers as fixed accessories. Wide Used on stepping motor driving guide rail, machine tool, and other equipment.
  • The fully threaded rod, we provide here, are in the size of: Material: 304 Stainless Steel; Color: Silver Tone; Thread size: M5; Thread Length: 25mm / 0.98 inch; Thread Pitch: 0.8mm / 0.03 inch
  • Threaded rod made of 304 stainless steel, provides great corrosion resistance and antirust ability for long service life.Fully threaded rods are widely applied in many occasions.
  • Instructions: select the appropriate size threaded rod, connect the nut on the machine, and tighten it
  • NOTE: All size above is measured by manual, please allow +/-0.1 inch error.



Product Description

thread rod

Advantages:

Threaded rod made of 304 stainless steel, provides great corrosion resistance and antirust ability for long service life.Fully threaded rods are widely applied in many occasions.

Application:

The fully threaded rod is mainly Used for assembly fastening, screwing into threaded nuts or tapped holes., U-bolts or hangers as fixed accessories. Wide Used on stepping motor driving guide rail, machine tool, and other equipment.

thread rod

drseale
Reviewed in the United States on January 29, 2025
Just as described
Ken Flaherty
Reviewed in the United States on August 11, 2024
high quality product, sized correctly, priced right, shipped quickly
Woodsman
Reviewed in the United States on June 28, 2024
Perfect for my oddball application
Ed B.
Reviewed in the United States on March 2, 2024
At first everything appeared great with these. Then one of my servo motors burned up. Turns out these are not all made too the same tolerance. Half of them slid nicely into a 4mm bore bearing. The other half were slightly oversized causing my servo to jam and burn up.
Vincenzo D Bruno
Reviewed in the United States on December 15, 2024
Bought as I lost the adapter piece for the antenna to my 2011 Ford Mustang in the car wash. Fit perfect in my after market short antenna and fit perfect into the OEM antenna mount on the car.
Bubba Warbucks
Reviewed in the United States on June 5, 2023
These are great if you understand metric sizing. I didn't and bought something I can't use. They're stainless steel and would have been perfect had I bought the right size