Your cart is empty.
Your cart is empty.
1.LED for energy saving and low maintenance cost.
2.Tested over 20000 hours of using time, durable for use.
3.These lights are sure to give you a visual status cue of any indexing signal, anticipating signals, emergency signal and other indexing signals.
Specifications
Model: AD16-22D/S
Light Color: Red, Green, Yellow, Blue, White
Rated Voltage: AC/DC 110V
Rated Current: ≤20mA
Mounting Hole Size: 22mm / 7/8inch
Continuous Working Life: ≥20000h
Brightness: ≥100cd/m2
Insulation resistance: ≥2M Ohm
Total Size: 51 x 28mm / 2.01inch x 1.1inch (L*D)
Package Content
10 x Indicator Light (2 x Red, 2 x Green, 2 x Yellow, 2 x Blue, 2 x White)
EMcC
Reviewed in the United States on February 4, 2024
Product arrived as expected, rated proper 110 voltage an with 2 sets of each of the five colors. Size was accurate. Bright enough for inside work, they were fine. I didn't try them outside in the bright sun. I only used 3 of the 10, but the 3 worked. Body and screw-on 'holding-nut' all plastic. There is a small rubber washer. I didn't have problems with stripping the terminal screws, that was OK.However, the wire terminals can not take much force on them. They nearly broke off from the plastic case, but fortunately maintained the electrical connection. I installed them in a tin metal project box, as part of a portable digital thermostat package. There wasn't much space, so there was a lot of finagling to get them installed in the case with the ring fittings coming off the terminals perpendicular to the light body. Good enough for hobby work or lab prototyping. I'd recommend something more solid for industrial applications esp in tight spaces--something that can take more force during installation.
MeccanoManStan
Reviewed in the United States on March 21, 2023
Used for septic pump system warning with buzzer lights too. They work.
ptolemy21
Reviewed in the United States on May 8, 2021
Perfect fit. Low profile. Easy installation.
Spencer Norby
Reviewed in the United States on February 24, 2021
Try and screw the power wires into it, and it pops apart. I'd not put it in anything running 110 volts. That's too much power for such a flimsy package. Could be deadly.
LL Williams II
Reviewed in the United States on May 1, 2020
I purchased these lights to use on an outdoor project. Yes they are advertised as panel lights I.E. most likely indoor panel lights. They are liquid proof. They are a good value. They do not show in the bright outdoor sun. Most likely my misunderstanding. I would give them 5 stars except for the outdoor problem
Jared Earley
Reviewed in the United States on December 5, 2020
Screw terminals break by barley tightening them.
John Beatty
Reviewed in the United States on January 21, 2020
I used these as status indicators for the ignition sequence on a crop dryer. Yes, they take a bigger hole ( 7/8” or 1/2” conduit knockout), but did a great job, sealed up well ( this is outdoors), and do what they are supposed to do. This is mounted to a 7-1/2hp fan, so has lots of vibration, but working fine. My only minor issue was that they wire from the back end, and was a bit tight in my crowded control panel, but even with my heavy fingers, I got them installed successfully. Price was very good too!
Recommended Products
