Your cart is empty.
Your cart is empty. 30 / 31 / 34 PICt MANIFOLD
This manifold allows for the use of 30 PICT-1, 31 PICT-3 or 34 PICT-3 carburetors without adapters. Manifold flange is drilled for either stud pattern and comes with heat risers, gaskets, and 1/8" pipe plug. Drilled and tapped for optional vacuum advance.
17-2805 30 / 31 / 34 Intake Manifold, Kit (Ref. P/N: 113 129 701AQ)
Customer
Reviewed in the United States on April 23, 2024
I don't mind the fact that you have to cut the tube's to fit and do a little bending. The worst part on this is the way the neck bends that you mount the carburetor to, the turn in the neck is so sharp that the mounting holes for the carburetor studs are to close to the neck. It's almost impossible to tighten the nut. Horrible design
Timothy Rotramel
Reviewed in the United States on June 24, 2023
This is a great intake manifold. Only problem I could see is if you put a 30 carburetor on there you’re not able to put nuts on I had to order a adapter for a 30 to 34 to be able to get the nuts on and bolted in other than that, I can’t set a great manifold.
zjenkins sr
Reviewed in the United States on December 31, 2022
Fits exactly like stock
harold
Reviewed in the United States on January 22, 2022
works great
Crystal
Reviewed in Canada on August 3, 2021
it needed to be modified to fit which should not have happened
Richmond Hughes
Reviewed in the United States on December 15, 2021
For like a charm
Raymond Osborne
Reviewed in the United States on March 2, 2020
Fit perfectly, easy install, I'm very pleased.
Thomas J Seymour
Reviewed in the United States on August 6, 2019
A+++++
Jeffrey Muth
Reviewed in the United States on March 17, 2015
I found the left pipe a little long for my type 1 but better that than too short. I chopped off about an inch and it now fits the intake boot and minifold like a glove (YMMV). The right side was fine. The heat risers come detatched with the kit and also need to be cut to length.They are a BEAR to install which is good since you need the tight seal. Still, for all the wrenching, it's better than my old cracked manifold.
Recommended Products
