Your cart is empty.
Your cart is empty.Gates Transmission Oil Cooler Hose is engineered with a synthetic rubber tube and an oil- and abrasion-resistant black CSM cover to provide a safe heat, ozone and chemical-resistant connecting line between the oil cooler and transmission.
Customer
Reviewed in the United States on January 20, 2025
Very nice quality hose. Flexible and rated for higher psi and temperature than most other similar hoses.
Phillip McClure
Reviewed in the United States on January 1, 2025
good replacement for transmission oil lines
Phillip vitale
Reviewed in the United States on August 12, 2024
Ok
D P
Reviewed in Canada on November 14, 2024
Parfait bonne dimension et robuste
Captain Ron
Reviewed in the United States on December 23, 2023
Perfect. Used to replace seeping oil cooler hose on my 1974 MGB. Good hose. Perfect for this job.
Guy Dufresne
Reviewed in Canada on September 15, 2022
fit properly
K. Nielsen
Reviewed in the United States on March 16, 2022
Needed to change the plumbing for the automatic transmission cooler on my 1964 Dodge Dart and these worked great.
Seb
Reviewed in Canada on June 1, 2021
Installation sur pick Ford Ranger 2007, et fit parfaitement pour remplacer le boyau de refroidissement de la transmission. grandeur 3/8 intérieur par 3 pieds long.
Adrian
Reviewed in the United States on October 8, 2021
It is to dimensions, it slid on well, able to cut to fit.... Durability is nothing to discuss now as I just put it on. Materials look good and feels well made.
jason r smith
Reviewed in the United States on October 18, 2021
It’s good quality transmission hose and is the size it is listed as….. will buy it again next time I need it, until then, I’m a happy customer
Customer
Reviewed in the United States on November 29, 2020
Perfect hose for using as a substitute for 11/32 ATF hoses. 11/32" hoses can be a royal pain to get installed since they are so tight. 3/8" is just a tiny bit wider and enough to make it far easier to install, while holding tight enough to not leak automatic transmission fluid. I ended up having to size down to 14mm spring hose clamps from the larger OEM hose clamps. The Gates ATF hose is thinner walled than the Toyota OEM ATF cooler hose.
K. S D
Reviewed in Canada on April 13, 2020
Absolutely high quality. I searched on their website before buying. They meet sae J1019 Standards. 400psi bust strength and 150 Celsius heat tolerance. More than adequate for a transmission cooler line replacement. I heated the ends with a hair dryer to get the hose over aluminum pipe as it was very tight. 3/8 inner by 3ft length. Made in USA as written on hose itself.
luc rioux
Reviewed in Canada on April 2, 2018
verry satisfied
Recommended Products
