Your cart is empty.
Your cart is empty.Voltage: 12 Volts RPM: 3300 RPM AMPS: 10 Dimensions: 8.38 (L) X 2.67” (W) X 2.67” (H)
Earl Bridges
Reviewed in the United States on March 5, 2025
Wrong fit. There are at least 2 different motors with the same part number but changes depending on serial number. This was too small for my finance and listing does not show info to determine if this is the correct one or not.
cornelius
Reviewed in Canada on February 8, 2025
Worked great to replacement old motor from 1997 that was making noise. In retrospect, was a bit of effort to service, would be worthwhile to see if new slide in replacements feature a much more serviceable design and/or flame detection as upgrades.Was well needing a cleaning but otherwise good, was some question about reusing the old rubber gasket for motor, but ultimately decided it was not intended for new motor and mounted without any issues.
Flash7481
Reviewed in the United States on February 1, 2024
I purchased for replacement of the 1999 SF-42 motor. Installing was impossible with loose posts. I'll try another hoping I just got a turkey.
Rob M.
Reviewed in the United States on December 27, 2024
I used this motor for the furnace in my 2000 Winnebago Adventurer 32V. It was wider than the motor it was replacing, but still fit fine. The only drawback was that I needed to purchase nylock hex fasteners to mount this motor to the blower motor flange, since the threads did not match the fasteners of the old motor. Has been working perfect for 6 months with no problems.
Steve Holowach
Reviewed in the United States on December 11, 2024
Bought to replace standard blower motor for my RV furnace. I went by the model printed on the standard label. The motor was smaller in diameter and could not be secured in motor / fan housing. It appears to be well built but returned due to size.
Ryan
Reviewed in the United States on April 17, 2024
This was mostly a fit for my pre-2001 Suburban SF-42 Furnace Heater. The mounting posts were a different thread than on the old motor so you'll need two M5x0.8 nylon lock nuts to mount this motor. BUT, the motor works well and got my furnace back up and running.
Recommended Products
$293.35
$ 99 .00 $99.00
$303.37
$ 99 .00 $99.00
$281.95
$ 99 .00 $99.00
$449.95
$ 99 .00 $99.00
$223.00
$ 99 .00 $99.00