Your cart is empty.
Your cart is empty.1/25 HP, Shaded Pole, 115 Volts, 3200 RPM, 1 Speed, 1.4 Amps, CW Rotation, Sleeve Bearing.
Nobody
Reviewed in the United States on December 1, 2024
Waste of time and money. Bearing only made it two weeks and it’s howling.
D C P
Reviewed in the United States on January 7, 2024
SAME AS ORIGINAL AND TRANE WANTS $550 TO$650 FOR THEIRS AND THEN WILL NOT SELL IT TO YOU
MA
Reviewed in Canada on January 13, 2023
Replaced the old part with this exact model in a Trane high efficiency furnace. This was the exact match, and less expensive than newer replacements.
The Oily Guy
Reviewed in the United States on December 9, 2020
Went on Amazon looking for a replacement fume pipe blower for my Trane gas furnace. Did a search and "bingo" there it was. Matched the part number and manufacture off the old blower, ordered and a couple days later I had it. Did the installation, it fit perfectly and is working great. You need some experience working with a gas furnace which I have.
Paranoid Survivor
Reviewed in the United States on December 3, 2020
Installed on my 15 year old American Standard 91% furnace. I worked as an HVAC installer for years. We always called these purge motors. This one went in pretty easy. Entire job was about 30 min. Do NOT just throw your old one away, you will need to remove the limit switch and an orifice cap and place them in the new one. The orifice cap is just a little black flexible cap that blocks off one of the two drain fittings on the blower housing. It can be changed depending on how the furnace was installed. The limit switch is self explanatory. It is a little tricky to remove the black wire from the limit switch connector on the furnace but you can figure it out. I suggest placing some clear silicone around the flange of the blower where it contacts the vent from the firebox. Makes for a better purge and allows your pancake vaccum switch to close easier. Decent price and it arrived in about 3 days. I'm satisfied.
Customer
Reviewed in the United States on July 12, 2019
Was easy to install
BobVan
Reviewed in the United States on June 26, 2019
Delivered on time. My original motor was working fine but the fan inside was off balance and rubbing against the frame. Since it is sold as a single unit by manufacturer, I replaced the entire unit. Replacement was quick and easy.
JsStuff
Reviewed in the United States on June 17, 2019
Perfect fit, went right in to place with no problems. Still working. Although my heating season ended about three weeks after installation. The blower is only used for the heating portion of the system. Thanks for the good information on part number replacement in your description. I am glad you had the all the other part numbers this blower goes by in your description.
Recommended Products
$274.99
$ 99 .00 $99.00
$286.45
$ 99 .00 $99.00
$74.95
$ 33 .99 $33.99
$223.00
$ 99 .00 $99.00
$97.95
$ 38 .99 $38.99