Your cart is empty.
Your cart is empty.This direct replacement timing cover matches the fit and function of the original equipment cover for a reliable repair. This part has undergone extensive testing to ensure adherence to precise design standards. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Acura CL: 1997] - [Honda Accord: 1994, 1995, 1996, 1997] - [Honda Odyssey: 1995, 1996, 1997]
steve h.
Reviewed in the United States on December 15, 2024
Its dorman..... worked ok with a little manipulation
Jeff
Reviewed in the United States on May 17, 2023
Good price, good quality, perfect fit.Works as intended.
Customer
Reviewed in the United States on June 22, 2022
Worked perfectly and fast delivery
motorhead clay
Reviewed in the United States on April 24, 2021
Complete cover kit with seals. Reasonable price.
SliCxRiC
Reviewed in the United States on December 11, 2018
Fit good. Gaskets a pain to get on and stay on when installing. Especially with the motor in the car. Recommend this part.
bud jones
Reviewed in the United States on December 6, 2017
this took a little bit of modifications to make fit. i have used Honda covers and they fit perfect. but the price is a big difference, if your willing to work with this cove it will fit.
Brian Czerwinski
Reviewed in the United States on August 27, 2013
Really wish I didn't waste the money on this - IT DOESN'T FIT!Just took the long way around my engine to fix an oil leak in the Vtec Solenoid (head gasket, timing, etc). When I took my head off I noticed I could easily break the inner cover off, and the lower was wore quite badly as well...So I tried replacing them with this.The inner cover by no means matches up to my engine, not one hole lines up...this means I had a heck of a time rigging the upper cover later.I got the lower cover to fit, although the shape of the back doesn't really match the engine, so I didn't see any purpose for the back gaskets.And finally the upper cover; I could not get this to match up at all, the angle is entirely off - about 1/2". It's a way different angle than the old upper cover, so the valve cover will definitely not fit over it. I ended up using the old upper cover.So in all, I paid $50 to replace the lower cover, with some of the gaskets.....booo
TColorado
Reviewed in the United States on October 22, 2013
Part 635-601 from Dorman for a 1997 Honda Accord SE 4 cyl F22B2 automatic.The upper and center covers are good. But the bottom cover has a defect on the left side.On the middle of the left side it has a nose like protrusion that is bigger than the original. This prevents the left side of this cover to lined up, seal and fit with the engine and center cover.After painfully wasting a lot of time trying to fit this cover, I pulled it out and compare it with my broken original and that's when I notice the defect.The nose like protrusion shape angle of the original is closer to 45 degrees but the Dorman part is closer to a 90 degree angle.IT IS DEFECTIVE, NO GOOD!
Recommended Products
$76.99
$ 29 .99 $29.99