Your cart is empty.
Your cart is empty.Product Description
This heater uses high temperature wire as the wire, heating quickly and long service life. With mounting holes for easy installation.
The power of the product is related to the use mode, heat dissipation conditions, environmental temperature and other factors. The rated power given by us refers to the power measured at the ambient temperature of 24℃. Under these conditions, the air temperature at 5cm from the outlet is about 50℃ Celsius. (when the ambient temperature drops, the power of the heater will rise.)
Safety, stability, energy saving, environmental protection and long service life are the most significant advantages of PTC products. The normal use of 5000 to 10000 hours, power attenuation is about 15%. (Unlimited times of switches)
Safety, stability, energy saving, environmental protection and long service life are the most significant advantages of PTC products. The normal use of 5000 to 10000 hours, power attenuation is about 15%. (Unlimited times of switches)
Mr. Tough Customerson
Reviewed in the United States on February 2, 2024
Pair (splice together) this with a 12v wall wart psu, attach to your 3d Resin printer. Viola! 3d Resin Printer heater. Fixed the errors I was having with my prints overnight. (yes I had to cut a square area out of my printer shield case with a dremel cutting wheel)
TRUC N.
Reviewed in the United States on December 4, 2023
Still working until now
A. Pierce
Reviewed in Mexico on December 4, 2023
Well packaged
Brad
Reviewed in the United States on November 3, 2023
Pumps out some major heat but I needed it to limit itself to 180 watts like the description said for my application and it instantly went up to 244 watts and stays there.
Bradley faircloth
Reviewed in the United States on October 7, 2023
Shipping was Extremely slow not sure if this is seller or amazons fault. Product seems to work but it seems heater shutting on and off (no there’s No thermostat)Will do some investigating and update if something goes wrong with it.
Thomas
Reviewed in the United States on December 30, 2022
Sits right at 218W at 24v.Could don’t appear to heat evenly, and the exterior gets hot, but otherwise runs efficiently and does what it’s meant to do.
Anatol Bobichev
Reviewed in the United States on October 29, 2022
Heater itself works perfectly in 3d-printer. 60mm fan started "growling" in a couple month of use (being installed outside of 60C zone. Manufacturer just cut corners. Pity.
Ricardo Occhipinti
Reviewed in the United States on November 15, 2019
Work quite good, realy usefull for low power industrial (24VDC) heating.
DragonNordique
Reviewed in Canada on December 12, 2018
Petit chauffage 24Vdc. Fonctionne très bien
Recommended Products
$426.20
$ 99 .00 $99.00