Your cart is empty.
Your cart is empty.2 Pack Wire Coupler Terminal with Set Screws, Brass Nickel Plated, 4 Gauge
Greg Johnson
Reviewed in the United States on September 20, 2024
Doing the job for my 0 vague wire
Jen
Reviewed in the United States on August 6, 2024
I used them with 4 gauge wire and they seemed to work, but it felt like the threads were ready to strip. I covered them in a heavy shrink wrap. I would not use them without the shrink wrap.
Tung Nguyen
Reviewed in the United States on July 24, 2024
I bought it to connect two section of #2 ground cable for welding. It is supper easy to use, make a good connection, had no problem so far.
Denis
Reviewed in Canada on July 16, 2024
J’ai fait un très bon achat pratique pour joindre deux fils super bien
BKL
Reviewed in the United States on June 11, 2024
First I purchased dorman butts but I would've had to use heating and crimping and for me. It was too much to do with such little space to work in. Then low and behold like magic, these surfaced and I was able to connect the new 1/0 Guage wire to my broken positive wire in minutes. It's made of super strong steel so it'll last forever and with the screw allen screws. I was able to keep the wires secure and keep current flowing for a strong reliable start every time.
Dennis B.
Reviewed in the United States on November 4, 2024
Quality product
D man
Reviewed in the United States on October 29, 2024
I keep these on hand incase I have some high current draw wiring get too hot and burn through, hopefully I wont need them.
Chris Gunterman
Reviewed in the United States on October 27, 2024
They work great. Trying to find the plastic kind of very hard. I will use these for now on.
Tonks
Reviewed in Canada on January 31, 2024
havent used yet but they seem sturdy. bigger than i expected perhaps
Rob Girkin
Reviewed in the United States on February 16, 2023
These are pretty decently made, but have a few design flaws. I bought 2 sets to use in coupling 6 gauge wire together going to feed a sub panel. I had read a prior review stating that you would need to back out the holding screws completely to get the wire inside the coupler. This was Correct. Removed the screws and the 6 gauge wire fit right in. But, the screws WILL NOT THREAD BACK into the coupler with the wire in place. Not 6 gauge stranded wire anyhow. And, the screws are fairly cheap, soft, and easily rounded out. I'll keep these to use down the road with smaller wire to save the hassle of returning. But, it stated they were for 6 gauge when I purchased them, and they were useless for coupling that size wire...FYI
Sergio
Reviewed in Mexico on November 29, 2023
Su calidad es aceptable para su precio. Pero siempre es mejor poner un solo cable sin uniones de este tipo.
VinnniE
Reviewed in Canada on April 13, 2023
Had no problems with the set screws nor the threads. I’ve put some blue loctite on the thread and heat shrink the joint.
D. Chasse
Reviewed in Canada on February 25, 2021
I use it to connect 10 gauge wire to 6 gauge wire and also to 8 gauge wire and works well. Thick wall with long screw to fit with 14 gauge wire and perhaps 16 gauge too but I have not test this case.
Recommended Products
