Your cart is empty.
Your cart is empty.
Want to lower the rear of your C4 Corvette? Look no further! This kit comes with everything you need and nothing you don't. Kit includes:
- Two 2" drop bolts
- Four washers
- Two nylon-locking nuts
- One instruction sheet
Bolts are SAE Grade 5, with an ultimate tensile strength of just over 18,000 lbs (way more than they could ever see holding up one corner of a 'vette!) Installation is extremely easy and doesn't even require removal of the wheels! This kit does not include new rear spring bushings - many kits include them (and charge quite a bit for them!) but we've found that most cars do not need a spring bushing replacement, so we leave them out and save you money!
The red '87 pictured has this 2" drop kit in the rear with the front height unmodified.
For those wanting slightly less drop, we also have 1" drop kits available.
Erin Turner
Reviewed in the United States on September 8, 2024
Simple, yet effective. Very easy install I paired with the energy poly bushings, super quick install and instant results. No more extreme wheel gap.
Frank P.
Reviewed in the United States on September 10, 2024
Good quality and correct grade bolts. Did what I needed it to do lowering the rear.
Anthony S.
Reviewed in the United States on June 29, 2024
These bolts will change the look and stants of your vehicle in 30 minutes or less by yourself. A very cost effective way to lower your rear end 2 to 3 inches
Alyssa Holmgreen
Reviewed in the United States on September 1, 2023
10 minute install. Rides just as smooth as stock but looks 100x better
Colorado man
Reviewed in the United States on November 6, 2023
Recommended. Need alignment after.
Josh Linville
Reviewed in the United States on October 29, 2023
Worked for the stance I was looking for!
Kole d.
Reviewed in the United States on June 18, 2022
Justin
Reviewed in the United States on September 2, 2020
I put brand new shocks on the front and rear the same time I did these. It does drop the back a little more ever so slightly if you do decide to change the shocks out at the same time.If you do get these and the shocks are at least a year old it will make it look perfectly level for sure. Doing it for my first time it was very easy. Might want to check your bushings first as well and buy some if they look worn. Lucky mine was stored in a garage for years and still have life left on them but I recommend now even if they are good to go ahead and replace them with good ones.Last thing to remember when installing these is to tighten the nut all the way up the bolt. I tired making it lower and it was not a good idea due to scrapping and pretty sure instructions say to do it as well.
Recommended Products
$160.70
$ 71 .99 $71.99