Your cart is empty.
Your cart is empty.If you want remove the gimbal bearing easily, please use this tool. The colour is black and oxide finish on all the parts to it. Fit for Mercruiser Alpha, Alpha 1, MR, Bravo's, OMC cobra's, Volvo's. The blind hole puller locks into the inner race of the bearing. The item comes with a storage tube for the threaded rod, and manual also. It is easy to use, just turn the end of the tool with a wrench. Feature. Remove the gimbal bearing easily 6.7lb. Comes with a storage tube for the threaded rod 18.5 inch x4.3 inch x3. Easy to use, just turn the end of the tool with a wrench. Specifications. Weight: 6.7lb (3kg). Dimensions (Lx Wx H): 18.5 inch x4.3 inch x3 inch (47x11x8cm). Fit for: Mercruiser Alpha. Alpha 1. MR. Bravo's. OMC cobra's. Volvo's. Package Content. 1 x Boat alpha bravo omc gimbal bearing puller remover.
bad item
Reviewed in the United States on March 30, 2025
do job
AndreyOregon
Reviewed in the United States on April 11, 2025
Very nice tool. Took me like 2 minutes to remove a stuck gimbal bearing in my Volvo Penta SX. I used 30mm open end wrench. Make sure you add extra grease or oil on the tool's threads.
DJ
Reviewed in the United States on April 11, 2025
Work says advertised, able to pull a gimbal bearing from a OMC Cobra outdrive without any drama.
jhog
Reviewed in the United States on July 23, 2024
Has always pulled the toughest gimbal bearings for us
John
Reviewed in the United States on July 12, 2024
Getting bearing out was easy, so mush better then a slide hammer.Good qualityEasy to use
Customer
Reviewed in the United States on December 27, 2023
While there were no instructions, and I was a little leary about pulling this bearing, I gave it a try this morning. I started by pinching the ends of the puller together so that it would fit into the bearing. Then after removing the center plunger, I threaded the puller onto the plate about halfway. Then pushed the end of the puller thru the bearing and positioned the plate over the outdrive studs, I pushed the plunger in to open the puller inside the bearing and gave it a few taps with a hammer. I then took a crescent wrench and backed the puller out. The bearing came out easily. In all it took maybe 5 minutes. I was using it on a mercruiser alpha 1 gen 2 1992 boat. Well worth the money.
Pete S.
Reviewed in the United States on July 9, 2021
Good toolPretty simpleAs simple as it is , wish it had instructions .. took me a minute to figure it out
Dan Musso
Reviewed in the United States on April 26, 2021
I watched alot of YouTube videos on how to remove gimbal bearings. I would say 75% of them said to use a slide hammer to remove a gimbal bearing . So as per video I tried the slide hammer trick please dont waste your time like I did with this method . Wasted a day trying to remove the bearing with slide hammer so I bit the bullet and purchased this puller. This puller is worth every penny easy to follow instructions . I used the puller exactly how the instructions stated and the bearing came out so easy that I figured I was doing it wrong till the bearing came out. I Would highly recommend this tool to anyone who likes to do there own repairs on their boat .
Recommended Products
$30.75
$ 13 .99 $13.99
$108.99
$ 44 .99 $44.99