Your cart is empty.
Your cart is empty.Includes one SM-DU BLTouch 1m replacement cable.
Manchurian Candidate
Reviewed in the United States on March 29, 2024
This doesn't fit the stock dupont connector that the BL-Touch has on a CR10 S5. the black and white cables don't fit into the receptacle and the cable count is offTotal waste of money.
Taylor B.
Reviewed in the United States on November 1, 2024
The product is designed like it needs to be.I had to double check the wiring and swap a couple of the wires to work for my application. Thankfully most tutorials had already mentioned I may need to do this so I would strongly suggest that you CHECK YOUR WIRING before full sending it!
John Engelman
Reviewed in the United States on January 1, 2024
Just a heads up that you may need to switch two of the pins for it to work with your machine.
melvin jeffery
Reviewed in the United States on December 18, 2023
The 3+2 pin connection is not keyed, so it comes out very easily. However, it is relatively cheap so if you wanted to solder on your own connection it could be okay.
dakota
Reviewed in the United States on January 28, 2023
Bought this cable to replace a well worn stock BLTouch cable. Upon installation, the Dupont connectors were extremely loose and would not stay on the motherboard pins. The weight of the cable alone was too much for the connector also. I'm sure this is a great cable for other printers, but this isn't for the Ender3 V2.
Mario Grado
Reviewed in the United States on February 22, 2022
Worked perfect was confused but that was on me
Dante
Reviewed in the United States on March 22, 2021
I was worried about other reviews saying they got a different picture than cabled, I received the exact same cable as in the picture in 1m length, works perfectly!
Dr. StrangeBrew
Reviewed in the United States on November 30, 2019
4 stars because I got a little confused. perhaps it’s just cluelessness on my part, but they could have made more clear that this is only one unit, not the three pictured.Despite the fact that it was the black end on the controller side, it is plugged in well enough on my Ender 3 to still work. I might replace the ends with the proper white ones if it has problems attaching.
Recommended Products
