Your cart is empty.
Your cart is empty.Product Description
soccerdad
Reviewed in the United States on February 26, 2025
Replaced a failed PT1000 sensor. Accuracy is excellent. It's worked for 2 weeks - so far so good.
Lonnie Tharp
Reviewed in the United States on August 26, 2024
Great thermistor, had it up to 400 and no problems so far.
prime numbers
Reviewed in the United States on May 13, 2024
Good wire insulation… works very well so far. In marlin changed temp sensor 0 to 1047… no problem. This with the copper heat block and 0.6 cm2 nozzle and you are good to go
Rebecca
Reviewed in the United States on February 7, 2024
manta m5p has a jumper you use with pt1000.. this thermistor reads around 130 c with jumper ... remove jumper and it drops to a reasonable temp.. buy with caution
Austen B.
Reviewed in the United States on November 8, 2024
Had to lower the resistance slightly in my config by like 50ohm to show within 1c of my bed temp at room temp.Temp readings fluctuate a little bit (less than 2c between min and max, reading may change a little between power cycles as well by up to 1c) at room temp but stabilize at printing temps.Using this with a 70w heater (maxglee 70w 24v 2 pack) heat block stays rock solid at whatever temp I set it to. Highly recommend.Tested up to 350c and held for about a minute, no issues that I can see. This plus the 70w heater are peace of mind that the electrical part of my hotend are no longer a bottleneck no matter what I decide to throw at it.
bms231
Reviewed in the United States on March 14, 2023
everything works as it should. however, the ender 3 v2 cables are 1.2 m long. this is common knowledge. I don't understand why everybody provides one meter cables that have to be extended which is what I have to do. please update your product to 1.2 or 1.5 m so that it can be used on more printers.i wound up taking some of the old wiring from the old thermistor and extending this by about 8 inches. i used JST connectors on each end of my extension and this thermistor cable so it is a plug and play extension. i then heat shrinked over the connection so they don't come unplugged and importantly re-hotglued the plug into the motherboard.for klipper, sensor_type is PT1000 per documentation.
J. White
Reviewed in the United States on October 29, 2023
This device seems to be what it says it is at a very reasonable price. It worked well with the Bigtreetech EBB36 CAN with built in MAX31865 chip. Temp readings seem consistent with other PT1000s in the same environment.
Yakov G
Reviewed in the United States on September 5, 2022
These are definitely pt1000. The leads are nice and long, using with a duet 3 toolboard. Tested with a thermocouple and reading is spot on at 24c and at 250c. Very happy with them.
Recommended Products
$23.99
$ 11 .99 $11.99