Your cart is empty.
Your cart is empty.
- Ideally for electricity equipments, textile machines, printers, ships, mining machines, etc for signals indication.
Steve Hobbs
Reviewed in the United States on March 2, 2024
This is a bright LED indicator light! Fits nicely with easy installation. Wire connections quick and secure.
Ryan Bentley
Reviewed in the United States on January 30, 2024
One of them was scratched underneath the protective decal. I have 240v AC going through them. Time will tell how long they last. Rather cheaply made, be careful tightening screws
Edward Z
Reviewed in the United States on July 29, 2023
They are larger than I expected but were easy enough to install. They are bright and easy to see.
Moises
Reviewed in the United States on December 23, 2023
They have been running for quite some time and are still like the first day.
Phil F
Reviewed in the United States on February 14, 2022
I bought these for a monitor panel that I built for 2 air compressors about 8 months ago. Green indicates power ON from the circuit breaker, red indicates compressor running under a load (compressing air) and yellow indicates running without a load (running at idle, not compressing air). They are wired for 220v and the lights are bright enough to be seen from anywhere in a 30 by 40 garage. I would have given them a 5 star rating, but one of the yellow lights has already burned out and needs replacing.
Pat G
Reviewed in the United States on November 16, 2020
bright and useful for many projects works with 120 or 240 volts either voltage is bright
A Ronan
Reviewed in the United States on March 29, 2016
Good quality ,I use them on standard 125vac and they work just fine ,still really bright and easy to see even on the lower voltage.
Jess
Reviewed in the United States on October 31, 2016
These three panel mount LED lights are easy to install and use. They require a 7/8" hole and have two screw terminals that provide a bare wire termination. I used mine to indicate whether my DPDT relay was in one state or the other. I connected the red LED assembly to one state and the green to the other - ultimately to indicate whether the circuitry afterward was enabled or not. These are fairly large and easy to see from a distance. I used a 120V circuit to power these lights and they are still plenty bright to be used as power indicators.
Recommended Products
