Your cart is empty.
Your cart is empty.Carl A.
Reviewed in the United States on September 15, 2024
Correct part!
Johnlee
Reviewed in the United States on July 25, 2024
Wrok perfect
David Johnson
Reviewed in the United States on July 23, 2024
I bought this to replace the drivers window motor in my Sierra. It fit and worked perfectly.This vehicle requires that the regulator be lowered a little (3" or so) while the window is held in the up position ( I used Frog tape). Since my window was stopped in the up position I had to loosen the window clamps and remove the motor cover from the motor. It's held on with two or 4 small torx screws. The inner ones are somewhat of a pain to get to. I used a small ratcheting right angle driver to access them and it was slow work but it worked. The motor is geared slow so it takes a lot of turns to get the regulator to move but patience pays off.When reinstalling the regulator make sure that the rails are inside the window pane and the clamps are plenty loose. Then just be patient working the regulator back into position. Don't forget to plug the terminal blocks back in and hook the lock cable back up when reinstalling the door panel.All in all, it took me about an hour from start to finish.
Humberto Gomez de Molina
Reviewed in the United States on February 21, 2024
I don't have the photo, but I could tell that, when I took out the damaged engine, it was exactly the Chevrolet parts. and yesss. It worked perfectly.
Recommended Products