Your cart is empty.
Your cart is empty.Fits: Lexus RX300 99-00
Jesus A.
Reviewed in the United States on April 27, 2024
After 20 days of the new part been on the truck and driven about 50 miles total the part failed, rubber came off the bearing don't waste your money
Barry B
Reviewed in the United States on September 10, 2023
Great fit on 2005 Nismo but be prepared for a lot of work taking the old one off. They have to be pressed on and off. I ended up grinding most of the old one off to make it come off faster and it did.I only have 350 miles on it at this time and that's really not enough to comment on part longevity.
Jennifer
Reviewed in the United States on March 3, 2022
This was a perfect fit. Half the price of the auto parts store. Very difficult to install.
Customer
Reviewed in the United States on December 28, 2022
fit 2003 1500 HD 4x4. Would buy again.
area51auto
Reviewed in the United States on February 18, 2021
I installed this center support bearing on my 2007 Crew Cab Frontier.....Took quite a bit of work to remove.....ended up cutting off the metal casing around the bearing exposing the bearing and then used a bearing puller from harbor freight.....had to cut off the metal in order to be able to get the bearing puller between the bearing and the drive shaft. Once it moved it came off easier. Installation was easy. I used a hammer and taped it in to place. I wouldn't have been able to remove it without the bearing puller (Pittsburgh 12 piece Bearing Separator puller Part Number 62593). Truck is a California truck with no rust.
adam picur
Reviewed in Canada on February 5, 2020
Didn’t fit my 2008 lwb Nissan Titan
Marc H.
Reviewed in the United States on June 30, 2019
Very nice product. The only thing I could say I didn't like was the oversized dust shield for the boot. I was able to use a heat gun and make it fit. I would not let this sway you away from purchasing this heavy duty part.
Brain
Reviewed in the United States on May 25, 2019
This does not fit my 06 GMC Sierra. Not even close. Has a 40mm ID and mine needs a 35mm id. I have apparently waited too long to retrn, hollar if you need one...i'll give you a smokin deal.i suppose its partislly my fault for noy putting my truck out of commission so i could measure the dadgum thing
Customer
Reviewed in the United States on October 7, 2017
Just wanted to state that this actually fits the 2006 Nissan frontier. The part was installed 5 days ago. So far so good. The 3 stars is because its early days yet.
Recommended Products
