Your cart is empty.
Your cart is empty. Model: 6204-2Z
Quantity per Package: 2 Pcs
Material: 100% Chrome Steel
Protection: Metal Seal on both sides
Greased / Lubricated: Yes
Bore (Inner) Diameter: 20 mm
Outer Diameter: 47 mm
Width (Thickness): 14 mm
Supported Revolutions per Minute (RPM): 20,000
Jesse
Reviewed in the United States on March 7, 2025
Used to rebuild an old South Bend lathe - good bearings.
EO
Reviewed in the United States on February 5, 2024
I used these bearings to replace the old ones on my old Powermatic 66 table saw. I'm sure these will last a very long time.
Patrick Carr
Reviewed in the United States on December 8, 2024
Didn’t know Timken is now made in China. They are tight and well lubricated. We will see how they hold up. Going into a 3/4 hp bench grinder.
Shopper
Reviewed in the United States on October 24, 2024
Great bearing at a low cost.
R. Redd
Reviewed in the United States on June 22, 2023
Just what I needed. Worked great.
Kim
Reviewed in the United States on April 16, 2023
I was needing a replacement bearing set for my Trucut C27 mower reel and found these to be the same dimensions as the bearings I needed to replace Except these are sealed on both sides. The originals were only sealed on one side.
larry k.
Reviewed in the United States on June 4, 2021
I believe Timken makes a great bearing . I have always been satisfied with the quality. I recommend these products and vendor.
Gordy
Reviewed in the United States on May 24, 2021
Put them in a 8inch bench grinder, smooth and quite, coast-down is fabulous. Great value
Recommended Products
