Your cart is empty.
Your cart is empty.Product Description
Ronald C.
Reviewed in the United States on September 18, 2024
They work great on my table router for trimming and tracing.
J. Sevier
Reviewed in the United States on December 23, 2024
You should consider this a disposable or limited use bit. For the price, it's still worth it if you're not running hundreds of linear feet of wood through it. Great for when you don't need the premium, hardwearing option.
Michael
Reviewed in the United States on December 21, 2024
I unpacked the bit and started using it, and the bearing came off while using the bit, ruining the project I was working on.
D4st
Reviewed in the United States on November 4, 2024
I got this bit to round some edges on picture frames and it worked very well. It was easy to install, rolled smoothly, and cut cleanly. I expect to get a lot of use out of it.
kelly ripley
Reviewed in the United States on November 20, 2024
Looks like a good and sturdy bit, when new guided along smooth and easy.Over the course of less than a week cutting patterns out of thin plywood ( about 2 hours cutting time) it was dull.
Brian J
Reviewed in the United States on November 2, 2024
Smallest one, bearings came off on first use. Could not find the bearings or the nut holding them on. Larger ones, but has remained attached.Maybe loctite the nut on before using would help.
Scott Davis
Reviewed in the United States on October 9, 2024
JGZUI. 1PCS Flush Trim Router Bit 1/4" shank. I used this five dollar JGZUI trim bit for a laminate counter top piece I did and it worked just as good as one of my Freud bits that are north of the $20.00 mark.Cant say If it will hold as a daily use bit but it got my attention as a an impressive little guy that did a real clean job for me👍
David Harrison
Reviewed in the United States on October 5, 2024
These flush cut bits are sharp and cut clean.
Recommended Products
$26.32
$ 13 .99 $13.99
$15.41
$ 7 .99 $7.99