Your cart is empty.
Your cart is empty.Product Description
Photocell Kit
Photocell Kit
For Reddy Remington Master Knipco Heaters Parts PP236 & M16656-24
Photocell Kit
PP236: Photocell Assembly should be used with 104068-02 ignition control boards on oil fired heaters.
Photocell Kit
Apply to DESA: Dayton, Knipco, Koehring, Master, Reddy, Remington, Sears, and TSC: (PP236, M16656-23, M1665623, M16656-24, M1665624) PINNACLE: ProTemp, Master, Remington, Heat-Stream, WorkHorse, Heat
Photocell Kit
This photocell is used with heaters that have the hot surface ignitor (glow plug). UNLESS you have the DESA upper tier heaters that have the plastic handle and shroud that covers the fuel tank. That photocell is part# M16656-21
John Reynolds
Reviewed in the United States on March 17, 2025
The wire leads where to short on the photo cell.
Katie
Reviewed in the United States on February 20, 2025
as advertised
Mariebie
Reviewed in the United States on December 6, 2024
Used this to repair a salamander heater, works perfectly.
Skynrd
Reviewed in the United States on January 6, 2023
I needed this for a heater in the shop, good value and did the job
joecooldaddy
Reviewed in the United States on January 28, 2023
Description was spot and easy to install fast delivery
chuck
Reviewed in the United States on February 15, 2022
In the description it lists the wire leads as 15". The leads are not 15" they are 12". If you intend on using this item for a Reddy heater t125 the heater will need to be modified before using this item
Brian
Reviewed in the United States on August 12, 2020
My torpedo heater wasn't working right and this fixed the problem.
Archie H.
Reviewed in the United States on December 9, 2019
Ok works fine
Recommended Products