Your cart is empty.
Your cart is empty.4 inches Straight Valve Extenders are durable, nickel plated, brass valve extender is angled to lengthen your front or rear tire valves. These extenders make checking and inflating your dual tires easy.
Carl
Reviewed in the United States on July 7, 2024
they look good
Richard C.
Reviewed in the United States on September 9, 2023
So much easier to air/check tires
Customer
Reviewed in Canada on May 19, 2018
delivered as promised. these fit well and are for duallys when the holes in the rims line up perfect.
Customer
Reviewed in Canada on July 20, 2017
the were great
Dave Arrowsmith
Reviewed in Canada on January 8, 2017
cannot install until winter is over--they look to be what I am looking for.
dave
Reviewed in Canada on August 19, 2016
work good but were a pain in th a$$ to install as the nuts on the ends spin and were hard to get to because of the 2 wheelson the coach
The General
Reviewed in the United States on June 24, 2016
The originals that wore out, were solid and could be easily installed and taken off. I found these to be a bit harder and required little hands to fit between the dual tires to install since these are a two piece unit and must be taken off the reverse way.
NformR
Reviewed in the United States on April 28, 2016
These come with a small rubber "o" ring seal in the female end. After one time installation the "o" ring is destroyed and freely falls out if for any reason the extender is removed. I can't even use the part or trust it to properly hold air pressure on my RV duals. I have way too much weight and pressure relying on this negligently poor design. Other extenders (Slime & Pacific Dualies) use a flat reusable elastomeric that is a much better design with a positive seal. I'm so very disappointed in this Wheel Masters design. I would counsel my friends and family to avoid this product...
Bummerx8
Reviewed in the United States on June 25, 2015
As another reviewer said, the end that screws onto your exsisting valve is not hard attached, it turns independantly. This makes these very hard to install on your inner rims, as you cannot reach in there to tighten the connection, which of course is critical/ These come lose, they leak, you have a flat.I took quality electrical tape, and tightly wrapped the end to the shaft, wrapped it about 5 times. This held up real well, i was able to turn the shaft onto the valve stem. You donot need these super tight, but loose is not good either.Of course none of this would be a problem if the wheel was off, a major job on a vehicle with 22.5" dual wheels.L.
Noah
Reviewed in the United States on January 9, 2015
This is just what I needed. I have a dually truck and I put these on the inside wheels to extend the valve stems. They poke out far enough to get at easily but still inside the wheels so it doesn't catch on anything. Great Product.
Ted L Heinfeld
Reviewed in the United States on June 11, 2014
I have a class c motorhome with duals on the rear. When I bought the rig the previous owner had installed the braided type of extensions. While they did the job it was a battle to get the proper inflation into the tires. By adding the stainless steel extenders to the value it is a simple operation. It seems these hold the tired pressure better.
E B
Reviewed in the United States on December 12, 2014
Nice design, fairly easy to install. Need 7/16 open end wrench to install. If installing on vehicle then you may need to tape a rod to open end wrench to extend length to get between wheels on dually. Not recommended for rubber valve stems because the stems will flex as wheels spin and may lose pressure.
Recommended Products
