Your cart is empty.
Your cart is empty. Features:
Easy and simple design
Suitable for repairing, replacing or making a clock
Material: plastic and aluminum
Second hand motion: Sweep
Accuracy Within ±30seconds deviation each month (in normal temperature)
Battery: one 1.5V AA batteries,not included.
Please DO NOT USE Alkaline battery,Rechargeable batteries,they will damage the movement.
Dimensions:
Case size: approx. 56 x 56 x 16 mm (2.2 x 2.2 x 0.65 inches)
Hands No.1
Total hour hand length: approx. 41 mm (1.61 inch)
Total minute hand length: approx. 55 mm (2.17 inch)
Total second hand length: approx. 64 mm (2.52 inch)
Hands No.2
Total hour hand length: approx. 53 mm (2.08 inch)
Total minute hand length: approx. 64 mm (2.51 inch)
Total second hand length: approx. 85 mm (3.34 inch)
Package included:
1 x Quartz clock movement
2 x Second hand
2 x Minute hand
2 x Hour hand
1 X Second cap nut
1 X Rubber gasket
1 X Brass washer
1 X Brass nut
1 x Metal hook
1 x User manual
Warm notice:
.The hour and minute hands had a protective plastic coating that needs to be carefully removed.
.Be careful not to bend the hands with too much pressure.
.Please do not use Alkaline battery, rechargeable battery, or they will damage the movement.
.Do not tighten the brass hex nut too tight.
.Press hard to get all clock hands in place.
.Check if all hands are aligned.
Scott Miller
Reviewed in the United States on March 3, 2025
The clock motor worked fine but none of the hands would fit the clock shaft. they did not have a large enogh hole to fit the shaft and were too small to be able to be drilled out. I was able to use the hands from the previous clock motor by enlarging the one for hours by removing a small section and bending it to fit. The minute and second hands from the old motor then fit ok.
Louise
Reviewed in Australia on February 8, 2025
Needed a clock with short hands and this worked beautifully. Nice hands to choose from. Easy to assemble.
GB
Reviewed in the United States on February 24, 2025
This sweep silent clock movement mechanism is fantastic! It operates completely noise-free—no more annoying ticking, just smooth, continuous movement. Installation was straightforward, and it fit perfectly into my clock project. The timekeeping is accurate, and the hands move effortlessly. If you're looking for a reliable, silent clock mechanism, this is a great choice. Highly recommend
Demian Garcia
Reviewed in the United States on February 24, 2025
Works works better than the original.
ROBERTA
Reviewed in the United States on February 18, 2025
Worked great. Directions were easy to follow
Dbrit
Reviewed in the United States on December 3, 2024
This clock movement and hands are very nice. The hands required a bit of nudging to properly fit on the shaft, but work great. Really like the sweep second hand. I recommend this!
Lorraine Bledsoe
Reviewed in the United States on December 20, 2024
The product looked nice. It definitely wasn't the size I needed. It is probably my fault on that one. Although, looking at the picture of it, the shaft looked long and when I got it, it was short. Therefore, it is of no use to me for what I needed it for. That's ok though. I will keep it in case I need it for another project. I like the hands. They were the perfect length, which I am unable to find on Amazon's website. I wish I knew where to get the right length shaft with threads at top and flat on one side. Thank you. I am sure your product is very good. I will use it sometime in future.
Ten Minute Drum Solo
Reviewed in the United States on November 18, 2024
Installation is a breeze, all necessary parts are provided - including optional hand styles. Perfect replacement clockwork!
John S.
Reviewed in the United States on May 12, 2023
Failed to keep time within 2 hours of installing. Fresh battery, installed correctly, gears jam up and stops running after just 2 hours. Not worth purchasing.
Brian
Reviewed in Australia on November 1, 2020
Works perfectly and was just as described.
Recommended Products
