Your cart is empty.
Your cart is empty.Ben Wilson
Reviewed in the United States on July 7, 2023
Easy work on nylon without melting it. Pushed it to its limits with a full 2" depth cut and even nicked a screw with it and it shugged it off. Buying more and more super great
Larry
Reviewed in the United States on May 28, 2023
Very sharp and did a great job cutting through 1/4 inch pvc in a single pass.
El wayo
Reviewed in the United States on February 20, 2023
Love em, been using it and easy and great! durable and excellent for my plexiglass cutting! Great and smooth too!
Mike C.
Reviewed in the United States on September 27, 2022
Bought these as a hopefully less expensive alternative to the Onsrud bits I have been using. The Onsrud bit would go many hours of nonstop cutting before it would need to be replaced. Both these bits broke within 10 minutes using the same material, speed, and feed rate.
Breahna
Reviewed in the United States on October 27, 2022
I've gotten about 10 or so of these bits and the last 5 of the bits we have purchased have broken right when we go to use them. They work great when they don't immediately snap in half.
JF31
Reviewed in the United States on April 9, 2022
I haven't cut with it yet but feels like I could shave with it. Picked up 2, might get 2 more. Made in China. Went to my favorite end mill mfg, GARR and they don't carry the 0 flute's. Went over to Harvey tool and they don't have a 1.5" LOC tool. Guess I have to go to China because U.S.A. MFG don't want to make a bit and sell it. Well, GARR and Harvey manufacture tools for 5 axis machines not for measly CNC routers.
Gary P. Jones
Reviewed in the United States on December 6, 2021
Cutting some HDPE, nice clean cut. Be careful very sharp. You always end up with some plastic threads wrapped around your bit. With router off, I ran my thumb down the bit to clean the threads off, and it cut me like a razor blade.
Aaron Methvin
Reviewed in the United States on November 18, 2020
Worked great cutting out core-last
Recommended Products