Your cart is empty.
Your cart is empty.
Material: Carbide
Preferred for small and medium removal rates on soft, tough and long chip materials such as aluminum, copper & brass.
Package Content
5pcs x End Mills
Please Note
- Better use the bit with cooling method.
- Stop immediately in the processing of anomalies when using the end mill bits and find out the reason before processing.
- Pay attention to the condition of wear and tear of the cutting edge and timely repair the end mill bits.
Jeffrey Fox
Reviewed in the United States on February 20, 2023
Best for the price
Mark T. La Plante
Reviewed in the United States on October 15, 2023
I have bought at least 5 sets of these now and they are holding up great. Surface finish isn't the absolute best, but I cant beat the price. When cutting flats it leaves small swirls no matter the feed rate. When cutting edges it leaves diagonal hairy lines. I have used Harvey tool cutters of the same size in the past with marginally better results, certainly not worth the 10x cost jump. So I am forced to do a cleanup pass with a different fine 5 flute cutter.
Bob
Reviewed in the United States on July 28, 2022
Nice and sharp, nice chip flow!
Mr. Spriggs
Reviewed in the United States on June 2, 2021
If you like throwing your money in the trash buys these bits. It didn't matter what speeds used the snap right off. I only drilled a few small holes before they busted again and again. Please look some where else.
Black Sheep
Reviewed in Canada on January 22, 2021
Perfect hobby bits. Great for soft metals , plastic or wood.
Tri Nguyen
Reviewed in the United States on September 19, 2020
The media could not be loaded.
Arianna
Reviewed in the United States on July 1, 2020
.05 DOC at 12ipm entry and 18ipm cutting and 7500rpm spindle speed and this little end mill can’t get through a single job. Any slower or shallower it’s a waste to even use. I’m tired of cheap end mills they’re hard to find higher quality in the smaller sizes. We prefer Gws alumigators or Kennematal kor5 for 3/8 and up. I will keep searching for better small end mills. It’s getting tiring for sure.
Sean Dolan
Reviewed in Australia on June 26, 2020
The bits are as described however they don’t seem to be able to cut aluminium without gumming up instantly. Tried many combinations and calculations of speeds and feeds and simply can’t get them to cut anything.
P. Meyer
Reviewed in the United States on December 19, 2020
I’m using these with an old dremel router accessory as a makeshift router table for free handing cutouts in 1/8” tinted polycarbonate sheets that I use as faceplates on weather stations. That stuff is difficult for me to work with since it chips and cracks easily. These cut through that stuff like, well not like butter but pretty smooth. I ran them at the lowest dremel speed and had to keep the feed rate down or the chips came off so hot they melted. I’m very happy with these bits.My dremel is at least 20 years old and the bearings are shot so the shaft can get to oscillating when using burr bits. That was easy to control with these, because they’re spiral cutters they don’t chatter. Even a new dremel tool would probably chatter with burr tools in that plastic router assembly.
Justin and Rachel Mays
Reviewed in the United States on November 16, 2020
Do not buy for aluminum or probably even wood (I didn't try it but I'm sure it wouldn't even cut that). No matter what your feeds or speeds are this product sucks. The one star is only so I could submit this review.
Recommended Products
