Your cart is empty.
Your cart is empty.Product Description
No More Refilling
Our kitchen sink tube kit is simple but effective.
One large dish soap bottle will last a couple of months.
No need fill soap so frequently.
The Real Cases from Verified Purchase
From pictures show, our sink dispenser extension tube kit would work for all the under sinks.
mike gabriel
Reviewed in the United States on February 20, 2025
The one-way valve does not work.Against every effort I've made keep it from being able to back siphon, it continues to drain back into the bottle.
Tomi Tharp
Reviewed in the United States on September 14, 2024
Why did I not know about these before? This was easy to install on current soap dispenser. The tubing was a little long so I measured and cut the length to fit in the large size dawn from Sams. I love this. No more filling the dispenser bottle once a week.
M. J. Wior
Reviewed in the United States on September 12, 2024
works great put it in my kitchen sink easy to install no more having to change the soap reservoir every few days hose could’ve been a little longer and could’ve used a few more bottle sizes for the gaskets caps but works great
Fearless Freep
Reviewed in the United States on August 20, 2024
At first I wasn't getting good results with this item. Them learned to cut the tubing so it's basically a straight run from the dispenser at the counter to the bottom of the jug o' soap. Voila! From that point on I always had at the ready. It does work best if you only need one or two pumps. I think it takes some "recovery" time for it to pull more soap up from the jug.I used to fill the little dispenser from the countertop. This inevitably led to me overpouring and getting Dawn all over the counter, or overcompensating and not putting a lot in there. Meaning I had to fill it more frequently. An entire family sized bottle of Dawn takes slightly more than a YEAR to run out since I can pull nearly every drop from the bottle it's sold in. With that bottle safely tucked away under the sink.It's possible this might not work for someone who has an overly crowded sink cabinet. But c'mon, if you can't fit a container of dish soap under the sink you may have more things to clean than dishes.
LCBD
Reviewed in the United States on December 18, 2024
Used this for over a year. Does not always pump a full squirt of soap. DO NOT throw away syringe given to prime the pump with soap. I've need it a couple of times. Oddly the directions said to throw it away.
RAK
Reviewed in the United States on May 15, 2023
WORTH every nickel to not have to fill up the little bottle! This was easy to install, works just fine, and you can buy the large 1/2 gallon/gallon size jug of soap and never have to crawl under the sink again, or fill from the top with over-spillage, or all the air bubbles that make it overflow!! JUST DO IT! The biggest difference is the metal tip at the end, keeps it 'weighted' so it stays on the bottom of the soap jug.
peggy0917
Reviewed in the United States on November 12, 2023
My only complaint is it took forever to suck the soap through the tube to get it to my kitchen soap dispenser. I even tried using my pool float pump, which both inflates and deflates, along with the provided syringe...and it still took a long time. The provided soap caps didn't fit well, but I was using a 50 oz bottle of hand soap. With a smaller bottle, the provided cap would have fit better. So far it is working fine and beats trying to refill the old set up.
Russ K.
Reviewed in the United States on May 16, 2022
I didn't know I needed this at first. I had a Moen faucet that came with a soap pump, but the tube that pump came with became hard and curled upward, so it would never get the last inch or two of soap from the bottom of the bottle. It was a constant fight of repositioning and seeing how much further it'd get.Now with this replacement tube and weighted check valve, it sits at the bottom of the soap bottle and gets it all. Conceptually it was very easy to install; however, the ID of the tube was slightly too big for the Moen pump. What I did was cut a small section of the original Moen tubing to connect to the pump, and the forced this new tube over and around the end of that small section. I then used a couple of zip ties as a clamp just to ensure it doesn't disconnect and air can't get in.Overall, I'm very impressed and will definitely buy this again when I get a house and can modify the bathroom sinks to also have soap pumps - I get tired of constantly refilling small pumps.
Recommended Products