Your cart is empty.
Your cart is empty.Product Description
Ferture：
Shank: 1/2 inch(12.7mm)
Blade Material: Industrial grade micro grain carbide
This 3 bit ogee entry door router bits set can cut rails and stiles between 1-3/8" and 1-3/4" thick. Cutting depth is 1/2" .Create rail and stile entry door frames with extended tenons.
Blade sharp
Made from cemented carbide, the blade is firm and durable, cutting efficient
Wide range of applications
Suitable for wood, MDF, solid wood, particle board, etc.
Durable
Made of overall hard alloy, long service life, not easy to damage
Specification:
Material: Hard alloy
Blade Material: Industrial grade micro grain carbide
Shank: 1/2 inch(12.7mm)
Chickenfax
Reviewed in the United States on July 9, 2024
I run a small cabinet shop - mostly hobby but some commercial. I needed to make a 1 1/2" thick set of swinging bar doors for a customer. This router set did the trick. I don't need to make thousands of these doors so super high quality wasn't that important. But I did make the set of doors out of oak and the set remained sharp.The rail end pieces set depth with a bearing so I machined all those first. Then the stile grooves have to be adjusted for depth with the fence on the router table. I set up to take 1/2" at a time - leaving a little bit for a third pass. Once I got done, the rails and stiles would not mate up. On the stiles bit, there are washer shims between the upper and lower. 3 are 0.020" and 5 are 0.010". I used a 20 and a 10 on each side which gave a perfect fit.These are hefty bits so turn the router speed down - I was at 2 out of 5 and slow your feed rate. I would recommend making multiple passes.Overall, I would recommend these bits!
Lori Abd El Mottelb
Reviewed in the United States on August 11, 2023
It went dull after first use and started burning through the wood, but no cutting. Save your time and money and buy something worth it.
Kindle Customer
Reviewed in the United States on March 17, 2023
It was cheap and I made a door 🤙
SLC
Reviewed in the United States on November 17, 2023
I ordered this for a special run of doors. I needed to match some existing pre fab doors and I didn’t want to spend much on a bit I will rarely use. The set was sharp and did a very good job on solid poplar. I probably would give 5 stars except for a little fuzzing and very slight chipping. That possibly could have been remedied by speed adjustments on the router.
rcroxs
Reviewed in the United States on June 4, 2022
I’ve built cabinets for the laundry room saved a fortune doing it myself with recovered popular wood I got for free they took a little time to figure out the combination but once I did it was great
Coni Kelly
Reviewed in the United States on July 17, 2021
They work well for the money
Marilyn Jones
Reviewed in the United States on June 11, 2021
Style and rail does not match, JUNK!
Frye's wood emporium
Reviewed in the United States on March 22, 2021
The bits where more than I expected quality wise.
Recommended Products
$25.95
$ 12 .99 $12.99
$44.95
$ 19 .99 $19.99
$38.95
$ 20 .99 $20.99