Your cart is empty.
Your cart is empty.The case is constructed of 1/4 Inch plywood with a heavy gauge nubtex laminate on the exterior and velcro friendly carpet lined interior. The case is assembled with aluminum extrusions machine riveted throughout and the corners are protected by steel flat corners. All the catches and surface handle are rust resistant and spring loaded. A simple pop-up and tilt setup allows your board to be raised approximately 7 high with a 2 height in the front. This can also be used as a standard pedal board case if you choose not to use the pop up and tilt option. It comes completely out of the case without fasteners. Simply velcro (not included) your pedals to the velcro friendly carpet lining in the case and you're ready to go.
Recommended Products
