Your cart is empty.
Your cart is empty.Warren campbell
Reviewed in the United States on March 7, 2025
Soft metal. Dont waste your time or money
Bob
Reviewed in the United States on December 8, 2024
One more tool for my arsenal! If you mess with motorcycles and other types of vehicles, you ought to have this tool. Anything that makes it easier to get a neck bearing race out of the frame is a winner. It is designed to be used in holes from 1-1/8" to 2-5/8". You could likely use this to remove some bearings too. When using it on a neck bearing race, simply insert the tool into the hole you are working on and spin the chrome shaft until the 2 black pieces are expanded out tight against the inside of the hole. Then get a punch, rod or shaft and hammer. Then start hitting the end of the punch, rod or shaft that is inside the hole. Be sure the item you are hitting is as large a diameter that will fit, so you spread the hammering load across the entire heads of the 2 black pieces.This puller appears to be pretty strong. Plating and construction seem to be adequate for the job the tool is intended to do.
romarosie
Reviewed in the United States on December 31, 2024
This made tapping out a head bearing cup on a K*M 890 easy and quick. Device just slides into the void, you expand it, then use a drift to tap the cup out of the head tube. Far quicker with less risk of messing up the head tube than gradually working it out with a drift around the edge. Very happy with such a very simple and effective tool. Extra benefit is its a very compact item, so it doesn't take up a bunch of room in the toolbox between uses. Just a minimalist solution that makes life easier.
Recommended Products
$72.86
$ 34 .99 $34.99
$183.98
$ 76 .99 $76.99