Your cart is empty.
Your cart is empty.JT Sprockets ensures maximum durability and performance through accurate machining and using only the best grade of SCM415 chromoly steel alloy. Heat treated and hand finished to perfection, all JT Sprockets meet or exceed the highest possible quality standards for the powersports industry. Each sprocket goes through 10 quality control checks before it leaves the factory.
Marcus Rudnick
Reviewed in the United States on March 8, 2025
I bought this under the guise it would fit my 2017 duke 390 and it does not, the center cut out of the sprocket is just a few millimeters wider than the output shaft on the bike, seems like a good quality part but disappointing, I also ordered a JT 14 tooth front sprocket so I hope that one fits.
Pacific NW
Reviewed in the United States on February 19, 2025
To make a long story short, it fits my 24’ klx300 dual sport perfectlyNow the long story, I measured my original 14t sprocket before pulling it off for offset and this new one is the perfect replacement except for it is a 13t. It fit perfectly on the spline and the lock washer and nut all set just right.I can feel the increase in torque with the 13t sprocket in all 6 gears and the overall speed is reduced by approx 7% which is not a problem if your not intending to ride 70mph highways for extended ranges. This sprocket makes 1st gear more of a crawler gear for tighter trails and technical areasGreat purchase at this pricepoint and I highly recommend this product to anyone with this bike “klx300ds” or one thats similar
Louie B.
Reviewed in the United States on February 14, 2025
Works great on my bike so far..
Scott Gill
Reviewed in the United States on September 11, 2024
Just what the KLX300 needed for the mountain back roads.
joe
Reviewed in the United States on May 1, 2024
I bought this and put it on my ninja. Works great. Now to drop a gear and disappear.
Malinda
Reviewed in the United States on November 7, 2024
This will fit on a klx 230 but you have to use a spacer on the inside of the sprocket. This will line it up and keep it away from the engine cases. I used an 18 gauge machined bushing from ACE hardware and it’s almost perfect.
Pablo M.
Reviewed in the United States on November 20, 2024
Straight forward install and it fit my 2023 Klx 300 perfectly!
Eliott Jorgensen
Reviewed in the United States on March 21, 2022
Great upgrade from 2020 KLX 250s.
Recommended Products
