Your cart is empty.
Your cart is empty. Description:
Make your own motor party with a motor shield and a fine assortment of motors! The original L293D Motorshield kit is one of our most beloved kits, We kept the ability to drive up to 4 DC motors or 2 stepper motors, but added many improvements:
Instead of a L293D darlington driver, we now have the TB6612 MOSFET driver: with 1.2A per channel and 3A peak current capability. It also has much lower voltage drops across the motor so you get more torque out of your batteries, and there are built-in flyback diodes as well.
Instead of using a latch and the Arduino\'s PWM pins, we have a fully-dedicated PWM driver chip onboard. This chip handles all the motor and speed controls over I2C. Only two pins (SDA & SCL) are required to drive the multiple motors, and since it\'s I2C you can also connect any other I2C devices or shields to the same pins. This also makes it drop-in compatible with any Arduino, such as the Uno, Due, Leonardo and Mega R3.
Completely stackable design: 5 address-select pins means up to 32 stackable shields: that\'s 64 steppers or 128 DC motors! What on earth could you do with that many steppers? I have no idea but if you come up with something send us a photo because that would be a pretty glorious project.
Tested compatible with Arduino UNO, Leonardo, ADK/Mega R3, Due, Diecimila & Duemilanove. Works with Mega/ADK R2 and earlier with 2 wire jumpers.
Package Included:
1 * TB6612FNG Stepper Motor Servo
Jefe
Reviewed in the United States on December 26, 2024
perfecto
YT - Poncheezy
Reviewed in the United States on August 16, 2023
Few pins did arrive bent but wasn't much of an issue to set them straight. You do have to be careful and not overly tighten the wire connector cause it will kinda twist when you go too tight. Currently using it to run fans on my sim rig paired with an Elegoo Uno Rev 3 and was able to get my fans running with Simhub. Could have probably been a little cheaper but for what I needed it works for now.
Ajmorales
Reviewed in the United States on March 23, 2022
La placa de desarrollo ayuda a trabajar con motores de forma correcta no sufre recalentamiento
Randy L. Jones
Reviewed in the United States on October 19, 2022
After about 10 minutes of bending and swearing, I finally got all the header pins straightened out. I have only bought a few things from this seller and they all seem to be poorly made. This is the last product I buy from them.
Hgamer
Reviewed in the United States on October 10, 2022
My motor shield came with bent pins and loose ports. If you applied a bit of force to the ports they would wiggle and a little too much force when screwing the wires in could potentially beak them. I was very cautious when using it in order to not completely break the ports and tried to unbend the pins. I will keep it because I need it ASAP for a project but I wouldn't recommend getting these from this seller.
Customer
Reviewed in the United States on November 18, 2021
I used this to run a couple large servos. Worked fine.
Marc
Reviewed in Canada on October 24, 2020
The 5V and ground pins were shorted out of the box and it burned my perfectly fine arduino uno. Save yourself the trouble and get the original. I returned this and got the adafruit.
Recommended Products
