Your cart is empty.
Your cart is empty.Product Description
Replacement for 2004 Cadillac Srx RWD Only A/T Replacement for 2005 Cadillac Srx RWD Only A/T Replacement for 2006 Cadillac Srx RWD Only A/T Replacement for 2007 Cadillac Srx RWD Only A/T Replacement for 2008 Cadillac Srx RWD Only A/T Replacement for 2009 Cadillac Srx RWD Only A/T About Installation: Easy installation and direct replacement
- After installation, the drive shaft should be calibrated to see if it rotates normally
High quality material drive shaft center support bearing. It is not easy to damage the base due to impact and vibration
It is installed on the drive shaft and plays a supporting role. Long-term use is allowed, precision machining is adopted, and the service life is greatly extended
If the drive shaft is not eccentric without inspection, the drive shaft hanger will wear and fall off, and the bearing will fall off
Mike Peterson
Reviewed in Canada on March 5, 2024
NOT GOOD!
Dustn
Reviewed in the United States on January 17, 2024
Product fit and worked well thanks
ron hensley
Reviewed in the United States on September 17, 2023
Perfect fit works great, fixed driveshaft vibration. Make sure to replace heat shield
camper 17201
Reviewed in the United States on March 13, 2022
Fits perfect as the center driveshaft support/bearing. Easy to install. Make sure to mark the two driveshaft halves as well ad the center cv joint and realign all pieces as they were which will Maintain driveshaft balance
jukka
Reviewed in the United States on April 27, 2022
Awsome deal , fast shipping
G. Harrison
Reviewed in the United States on June 20, 2021
The mounting bracket is no where near the same size as the OEM bracket.You will either hate to fabricate spacers or press the rubber bushing and bearing out of the new part and install in OEM bracket.BUT! The rubber bushing is a smaller diameter so I had to clean the inside of the original bracket and center the bushing with Permatex black adhesive.Dry overnight and install..If you use the aftermarket bracket the drive shaft will not be straight and it will not bolt up correctly without spacers..Just poor quality and they never tried to duplicate the original bracket.
Livinshowcars
Reviewed in the United States on December 9, 2020
Product didn’t fit properly and honestly very poor quality.Ended up having to take off a week after installing and throwing it away.
Bill
Reviewed in the United States on November 24, 2020
it wasn't an exact replacement for my 2004 SRX AWD, even though it was advertised as such The bearing and bracket were fine. The silver dust shield was different size than the stock one, it would not fit correctly. I left it off. I gave 3 stars because it saved me $$$ from replacing the whole drive shaft.
Recommended Products