Your cart is empty.
Your cart is empty.Product Description
LED Door Lights Logo Pojector
2015-2023 XC90
2018-2023 XC6
2017-2023 S90
2020-2023 S60
2017-2023 V90
2020-2023 V60
2018-2023 XC40
Super performance
Use high brightness LED chip, high light transmission three-layer combination of lights, very bright light output, very low power consumption, higher quality laser etched projection glass to ensure clarity never fade, never blur
It just take you a little while to install
Step 1:
Use a screwdriver to pop out the original light carefully.
Step 2:
Push down the clip to remove the wire. Notice: Do not let go of the cable.
Step 3:
After removing the original lamp, plug in the projection lamp
Step 4:
Finally the projection light will be installed on the car door
Product Function
Use car welcome projector light, when the door is open, LOGO in the open door surface lights up, providing light to assist in entering and exiting the vehicle to remind others to avoid mistakenly get out of the car, so that the owner can not see the road under the feet to avoid puddles or other obstacles on the ground.
Ojay
Reviewed in the United States on March 10, 2025
Easy to swap out for my make & model, and works great so far!
Don Eumar Galapon
Reviewed in Australia on September 4, 2024
Very easy to install and works great. I just hope it lasts.
Chris ogden
Reviewed in the United States on September 24, 2024
Love it! Just as advertised it took one or two minutes to install. I love the look of, better then I expected!
Mule
Reviewed in the United States on March 8, 2024
Very cool! Just got a new 2024 S60 and had this bling ready. Have to admit when i first pryed the light out I was dismayed by the zero length wiring harness!! What you see pictured is as far as it comes out! I backed off for fear of losing it if it sprang back into the door panel. After a few days, I put some thought in it and chose the tools you see pictured. The picture framing wire worked great with a few twists and it held the harness fine. Using the angled poker freed the green tabs and also allowed for a bit of leverage attempting to resnap the new light in. No definitive snap of the green tabs really into place but it is a snuggish fit. Hope this helps others if you have zero wire to pull out.
Keith
Reviewed in the United States on November 13, 2024
Product is great. As others stated, wires inside door panel short! Volvo C40 Recharge has 2 screws bottom panel. Remove them and use plastic pry tool to pull out bottom enough to wedge something in to hlmd the panel out enough so you can reach behind to plug into new light. First door took me 15 minutes to figure this out. 2nd one went I really fast. Just take your time. Worth it They look awesome. Disappointed my rear doors do not have puddle lights.
Berto
Reviewed in the United States on October 28, 2024
These projector lights look great, how ever they are almost impossible to install without first removing two 7mm screws holding the bottom door panels on a Volvo C40. Once you do this they are very easy to install. It is not the lights fault, it's the manufacturer that provided no slack on the wiring. Remove the two 7mm screws and get your fingers behind the panel to assist with plugging the units in. Overall they look great!
DIG
Reviewed in the United States on April 30, 2024
Great quality product, easy install, perfect fit. Installed in my Volvo XC70 MY 2016Very bright and laser sharp logo, it doesn't even have to be pitch dark to see the logo.
Inwester
Reviewed in the United States on June 4, 2023
Bought this set of 2 logo projector for my 2020 Volvo XC90 for about $30.Easy installation and just do exactly shown here in the video and in product installation.Step 1 - use a screwdriver or a plastic pry tool and pry out the OEM LED. Be gentle work the sides and take your time, it'll come out. Work from the sides as shown in the product description.Step 2 - use the projector marked L (left) for driver's side (for LHD cars). I didn't pay attention to this at first and had to redo because the logo was upside down.Step 3 - push down on top of the green connector to unplug the original LED bulb and reattach to the new projector.Step 4 - push it in and it'll stay in place.Step 5 - repeat with the passenger door and R (right) projector.Step 6 - enjoy the little joys in life :-)Overall it's 5 stars although it's priced a bit higher. You can find the same thing on the websites that ship from China for less than half the price but I didn't want to wait or deal with the hassle of return in case it didn't work.
Radhika Chakravarthy
Reviewed in the United States on December 19, 2023
First impressions: Great product. The projected image is bright and sharp. Installation was a bit of a struggle on my 2018 XC60. The wire for the existing lights is too short so it's not easy to disconnect them. Make sure you hold on to the wire once you unplug the existing light so that it doesn't retract into the door. Connecting the new ones and clipping them back into the door was easy. I bought 4 lights for all doors. The lights have R & L marked which is helpful but I found that for the rear doors, you have to use the left one for the right door and vice versa, or else the image is upside down.Overall, very pleased with the product. I just hope they last.
Recommended Products