Your cart is empty.
Your cart is empty. The PoE Splitter splits a PoE signal into an 5VDC power and 10/100Mbps ethernet data source.
This device allows you to run ethernet cables from a PoE Switch over long distance, and then split the PoE signal into a separate data signal and 5Vdc power sources in order to run an non-PoE devices.
Specifications:
Input: 44-56VDC max ; Shielded RJ-45 female;
Output: 5VDC 2.4A 12W Max.,
DC Jack: USB C
Length of output cable: 19.0cm
Operating Ambient Temperature: -10 to 45℃
Regulatory IEEE 802.3af
What is included
4x 5V PoE splitter
Note: this 5V PoE spitter is only compatible with 10/100Mbps non-PoE devices, it DOES NOT support gigabit non-PoE devices.
Ghost
Reviewed in the United States on October 8, 2024
Tried to use those on two Cisco switches with PoE. In both cases the adapter delivers poser to the device but the Ethernet connection is not established. I use the default auto negotiation setting but I am noticing it's not even trying to negotiate as if the switch port does not detect a device on it.
Justin
Reviewed in the United States on January 20, 2024
Power functions properly, but unable to deliver data to Raspberry Pi.
Cory M.
Reviewed in Canada on June 1, 2023
POE portion powers my Foscam just fine but when trying to use the wired connection it constantly disconnects. Tried many different ways without success. Even tried using external power and just the Ethernet pass through without success.
Geof Buchignani
Reviewed in Canada on January 23, 2023
I use these all the time to power devices in my customer's AV racks. Paired with a managed POE switch and you have complete power control of these devices in case of a needed reboot.
Informatique CFDL
Reviewed in Canada on January 20, 2023
Parfaitement fonctionnels pour transporter du POe vers des caméras 5V ( Yeskamo)
Recommended Products
$49.99
$ 26 .99 $26.99