Your cart is empty.
Your cart is empty.Paul Giorgio
Reviewed in the United States on March 3, 2025
My mechanic installed this product on my 2013 Jeep Wrangler. It leaked like a sieve. My mechanic tells me that the area around where the o-ring is, was not machined correctly. Can anyone do their job right?
Jesus A
Reviewed in the United States on March 10, 2025
Good quality
Dion’s Auto Servicenter
Reviewed in the United States on February 15, 2025
All gaskets and oil filter with sensors Great deal, just one sensor is the cost of the entire item
Chris T.
Reviewed in the United States on January 9, 2025
Better than the original plastic one
kelvin oneal
Reviewed in the United States on January 4, 2025
Work great for my truck
maria
Reviewed in the United States on January 21, 2025
Worked perfectly all the sensors were an exact match. Hopefully it holds up another 80k miles
Abraham t.
Reviewed in Mexico on July 6, 2024
Parece de buena calidad viene listo para instalar !! Tal y como está en la publicación .todo bien!!
yaaargle
Reviewed in the United States on June 1, 2024
I had to do spark plug change for a 2014 WK2 Grand Cherokee with 3.6L Pentastar, and a 2016 KL Cherokee with 3.2L Pentastar, and discovered that Chrysler, in its infinite wisdom, decided to directly mate the plastic oil cooler housing on top of the aluminum engine block. This is an obviously bad design choice, and it's a matter of when, not if, the oil cooler housing will fail, from the combination of heat and vibration.Another issue is the oil filter housing is known to crack when people put too much torque while tightening the filter cap. While this is more of an issue when you take your vehicle to less-than-reputable places for oil changes, where torque wrenches just aren't a thing, the fact plastic becomes brittle with heat and age means it will eventually crack even with the proper torque specs.Since I had to take out the upper manifold to do the spark plug change, I decided to take a couple of extra steps to remove the lower manifold and drop an aluminum oil cooler housing in. In both instances, this part was a perfect fit, and I didn't have to do any wiggling or mad science to make it fit because it's the exact same shape as the OE part. Additionally, the oil temperature and pressure sensors were both already torqued down and had threadlockers, so I didn't have to deal with them.I didn't use the included manifold gaskets for both installs, and went with sets of Fel-Pro. I also changed out the included oil filter with Mopar MO-349, and the plastic oil filter cap with a chromed aluminum one that is also available on Amazon.After driving both for a bit, there wasn't any indication of leak. The sensors on both sets are fully operational. All in all, the aluminum oil cooler housing is definitely worth installing if you're about to replace the spark plugs on your Pentastar, as a peace of mind.
Francisco Padron
Reviewed in Mexico on February 2, 2024
Lo instalé en una Grand Cherokee 2015 3.6 L todo bien, el empaque llegó entero y no faltó ninguna parte.
Bryan Russell
Reviewed in the United States on January 17, 2024
I like the price but when the oil sender doesn’t fit the vehicle it says it fits then you’re spending $70 at the dealer for a sending unit that the seller says fits your application. A 2016 wrangler doesn’t use the old 3.6 sending units. The new model uses a smaller oval plug.
Recommended Products
