Your cart is empty.
Your cart is empty.An ACDelco Professional Ball Joint is a high quality replacement for many vehicles on the road today. It connects your vehicle’s control arm to its steering knuckle. This ball joint features a polyurethane dust boot, a one-piece housing, and advanced bearings. It also has coated, heat-treated studs and includes all hardware. This premium aftermarket replacement component is manufactured to meet your expectations for fit, form, and function.
Ethan Yarnell
Reviewed in the United States on August 3, 2024
Great ball joint I’ve had it on for several months and it’s still works like new
Nicholas
Reviewed in the United States on May 3, 2024
I like that it has rings to seal the boot and the nut that comes with it is like original one.
Alex R.
Reviewed in the United States on February 25, 2024
No se que pasa he ordenado otro juego de ball joints pues el vehículo usa dos arriba y dos abajo, pero de las 4 unidades solo uno venía con su hardware, en las otras tres unidades no venía nada de tornillos tal como está en la descripción por eso le doy 3 estrellas
josh whitacre
Reviewed in the United States on December 3, 2024
The ball joint showed up and looks as advertised, however, none of the nuts and bolts came with it for installation! How am I supposed to install it without them. If they aren’t included, why are they pictured!
S
Reviewed in the United Arab Emirates on April 17, 2022
V. Good.
Flinstone
Reviewed in the United States on September 6, 2021
Easy install. Front end tighter now.
Matt West
Reviewed in the United States on July 26, 2021
Not easy to install. Lots of grinding and drilling. But when you prep it right, it bolts right in. Works great.
ANO wrench services
Reviewed in Canada on July 6, 2020
Fit perfect and grease able. No issues with quality and would buy again went into 97 gmc c1500.
alo len 62
Reviewed in Canada on August 23, 2019
Fit was perfect easy installation. 90% of work was removal of old ball joint - manipulating lower control arm critical to easier removal of old - wire bearing assembly or CV joint may come apart. Castellated nut (cotter pin slots) is a loose 1", suspect it's 25mm. 90 ft-lbs torque so... proper wrench ? Impossible to use standard torque wrench. However the pin holes must be aligned so chimp tight then last little bit to align pin hole.
JJ
Reviewed in the United States on April 11, 2018
Great deal on ACDelco Professional. Just installed the left and right uppers today, and was pretty straight forward.
Moabfool
Reviewed in the United States on September 1, 2015
This is a quality part, but don't buy it. Spend $15 more and get a whole new control arm with bushings. If the ball joint is bad the bushings probably are too. Save yourself the pain of drilling out the rivets of the old ball joint and installing the new ball joint, only to have to turn around and remove the whole arm, press out the old bushings, press in two new bushings ($15 EACH), and reinstall the arm. Just get a whole new control arm (or two).
Recommended Products
$41.15
$ 18 .99 $18.99