Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 812-Royal Blue Plush Cut Pile. Other colors and materials may be available in the selection above.
- This aftermarket carpet is a replacement for 1984 to 1988 Toyota Extended Cab Pickup Truck.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1984, 1985, 1986, 1987, 1988, 84, 85, 86, 87, 88
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point on both driver and passenger sides. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
dex
Reviewed in the United States on March 13, 2024
Bought for my 94 Toyota xcab and it doesn't reach the rear. I need an extra 6 inches under the rear seats :(
Brian
Reviewed in the United States on March 3, 2023
This carpet was WAY oversized, was not formed to fit floor board.Did not have shifter hole cutout, did not have seat holes cut out, did not have seat belt holes cut out. If you use this product expect to do a lot of cutting.Would NOT recommend this product,over priced for the quality and condition.
Luis
Reviewed in the United States on December 25, 2021
The pre molded areas were ok. It did require quite a bit of trimming. One would think with all the technology and tools the carpet would be trimmed, molded and ready to drop in with very little trimming.
Brandon Howard
Reviewed in the United States on October 12, 2021
Few really well makes the truck look new inside had lots of material on the side for cutting to fit perfectly
nicolas sample
Reviewed in the United States on March 7, 2020
Poor fit
Recommended Products
