Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 521-Dark Saddle 80/20 Loop. Other colors and materials may be available in the selection above.
- This aftermarket carpet is a replacement for 1960 to 1966 GMC Standard Cab Pickup Truck, 2 WD Automatic (3in Low Tunnel).
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1960, 1961, 1962, 1963, 1964, 1965, 1966, 60, 61, 62, 63, 64, 65, 66
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
Timothy M Garvey
Reviewed in the United States on November 3, 2024
Looks awesome and fit very good. Just a little trimming. Thanks
Lyn j Aevermann
Reviewed in the United States on October 10, 2023
Thanks
camper
Reviewed in the United States on May 26, 2021
Looks beautiful. Nice workmanship Better than new look.
Gavin Isaak
Reviewed in the United States on November 4, 2021
I ordered the gunmetal gray, and it is the perfect color, I got the 80/20, and it is tight, smooth and even. It fits pretty well in my 63 C10 low trans hump, but does need to relax more into position over the tunnel. Because of the tightness it pulls back away from the kickpanels just slightly on each side. It will fit though, I have stretched and pulled it over into position so the length is right, just needs to relax into place a bit better. I did sit it in the sun before install, but with it being alot cooler out right now, and still working the interior I won't be getting it out to sit in the sun for awhile, but I feel it will settle in once I do.
steven thibodeaux
Reviewed in the United States on December 16, 2019
Replaced 1963 Chevy C10...perfect.!
Michael H.
Reviewed in the United States on June 7, 2017
It fit well but could have been about an inch wider in the front part.
Recommended Products
$197.95
$ 92 .99 $92.99
$145.29
$ 70 .99 $70.99