Your cart is empty.
Your cart is empty.Catina Topash
Reviewed in the United States on March 20, 2025
These are an exact fit for my Husqvarna 150BT leaf blower!
Grandpa
Reviewed in the United States on February 13, 2025
Exact fit and great price
Deb
Reviewed in the United States on April 2, 2025
Hopefully they work when I need them.
An Ol' Longtime Customer
Reviewed in the United States on September 23, 2024
I was able to replace the primer bulb and fuel lines with these parts and the chainsaw started right up. Good products!
Kevin Dean
Reviewed in Canada on September 18, 2024
Doesn't fit
Sébastien
Reviewed in Canada on August 6, 2024
S’installe en un clin d’œil et fonctionne parfaitement. Très heureux, ma scie mécanique fonctionne parfaitement
Siska cycles
Reviewed in Canada on June 5, 2024
Worked great
Adam Greenberg
Reviewed in the United States on April 20, 2024
My old primer bulb on my husqvarns chainsaw dried up and cracked to pieces. Unfortunately its unique design made it impossible to replace locally.I was able to make this one work with some struggle because it was a very tight fit.
Brewingbiker
Reviewed in the United States on September 12, 2023
My Huskvarna chainsaw primer pump started leaking -as is common with these things, a small crack developed in the pump dome.These fit perfectly, you get far more than you need (needing only one bulb pump and just a little hose -if the old hose is bad) so you have plenty to put away for the future.This is a good purchase because the saw will easily last long enough to need these pumps replaced in the future -if you take care of your saw.A solid purchase!
Colin
Reviewed in Canada on June 16, 2023
Primer bulb works like it should.But the fuel line is smaller in diameter then expected. I wouldn't count on it fitting snugly to seal the gas tank if you were to replace the fuel line.
James P.
Reviewed in the United States on February 22, 2023
The bulb is easy to install. follow youtube to figure out how to install fuel lines on a husq 240 or 235. Youtube's Inside House Garage does good videos on these saws. Have to remove carb to replace fuel line. The smaller fuel line going from fuel filter to carb is OK size, the larger fuel line is way bigger than OEM on saw. I made it work though. Cut a real sharp angle in the line, like 1.5 inches long, and poke it in gas tank hole from top. Then you need some long, REALLY long needle nose pliers to grab it from inside the tank. The pliers fit in the gas tank fill opening. I had to buy some special long needle nose pliers at HArbor Freight. Once you grab the line, pull HARD!. the fuel line is strong against tearing. I kept using original carb, fuel filter and spark plug. This saw had sat for years with fuel in it. I cleaned carb screen with carb cleaner spray but would not run. So I closed both mixture screws clockwise and unscrewed them both 2 turns and it started.
Fred Johnston
Reviewed in Canada on November 15, 2022
I liked that it worked. I didn’t like that I had to figure out that you have to cut the line at a angle in order to fit it in the hole to the gas tank. Instructions would be helpful as not everyone is mechanical enough to figure it out. Check out your vent to your fuel tank. I think that was my real problem
Ryan Royal
Reviewed in the United States on October 15, 2022
My old primer bulb in my husqvarna chainsaw had dry rotted in the garage and these fit perfect. Took about 3 minutes to replace and after a minute or 2 of priming all the air out the chainsaw is as good as new.
Recommended Products